Home▸Chemistry & Materials▸Adjust Crosslink Density to Compare Thermosets and Thermoplastics

🧬 Thermoset vs. Thermoplastic: Crosslink Density

Tune crosslink density on a tangle of long polymer chains and watch the same material behave completely differently: at 0% crosslinks the chains slide past each other and melt/flow when heated (a reshapable, recyclable thermoplastic); with covalent crosslinks added, the chains lock into one 3D network that resists heat-driven flow and chars/decomposes instead of melting. A stretch test shows the uncrosslinked material staying permanently deformed while the crosslinked network snaps back elastically, with live crosslink density, meltability state and elastic-recovery readouts.

Chemistry & Materials3DModerate60 FPS
Adjust Crosslink Density to Compare Thermosets and Thermoplastics ↗ Open standalone

Tune the covalent crosslink density on a tangle of long polymer chains and watch the same backbone chemistry produce two completely different materials: an uncrosslinked thermoplastic that slides, melts and flows when heated, or a crosslinked thermoset network that resists flow and chars instead — with a stretch test to compare permanent deformation against elastic recovery.

🔬 What It Demonstrates

Each chain in the tangle keeps its own covalent backbone regardless of the slider. At 0% crosslink density there is nothing holding different chains together, so heating them lets the chains slide past one another and sag into a puddle — a real thermoplastic melt. Add covalent crosslink bridges (amber bonds) between chains and the whole tangle becomes one connected 3D network: heat can no longer make it flow, so instead it slowly chars and darkens, which is what real thermosets do when overheated instead of melting.

🎮 How to Use

Drag the crosslink density slider from 0% (thermoplastic) toward 100% (densely crosslinked thermoset) to add or remove covalent bridges between chains. Toggle Heat to raise thermal agitation and see the material either melt/flow or char depending on density. Run Stretch test to grip the network from both ends, pull it apart, release it, and read the live elastic-recovery percentage once it settles. Reset restores the original tangle without changing your crosslink density.

💡 Did You Know?

The molecular weight between crosslinks (Mc) — how much chain there is between each junction — directly sets a rubber's stiffness: fewer, sparser crosslinks give a soft, stretchy rubber band, while a densely crosslinked network like an epoxy resin barely stretches at all before it either recovers fully or fractures.

⚙ Under the hood

Adjust the crosslink density to see thermosets and thermoplastics behave differently when heated.

Three.jspolymer chemistrycrosslink densitythermosetthermoplasticvulcanizationpolymer network

3D · Three.js / WebGL renderer · 60 FPS target · runs fully client-side, no install

What did you find?

Add reproduction steps (optional)