Both thermoplastics and thermosets start out as long polymer chains, but what happens between the chains decides everything. A thermoplastic — polyethylene, PET, nylon — has no permanent bonds tying one chain to its neighbours, so heat lets the chains slide past each other and the material melts and flows, which is exactly why it can be melted down and reshaped or recycled. A thermoset — vulcanized rubber, epoxy, bakelite — has covalent crosslinks welding the chains into one giant 3D network. Heat can't make a single continuous network flow, so instead of melting it chars and decomposes at high temperature.
Vulcanization — heating natural rubber with sulfur — was discovered by accident by Charles Goodyear in 1839. The sulfur atoms form exactly the kind of crosslink bridges modelled here, turning sticky, meltable raw rubber into the durable, elastic, heat-stable material used in tires. More crosslinks (higher sulfur content) means a stiffer, less stretchy rubber — the same density/stiffness trade-off you can tune with the slider.
Tune the covalent crosslink density on a tangle of long polymer chains and watch the same backbone chemistry produce two completely different materials: an uncrosslinked thermoplastic that slides, melts and flows when heated, or a crosslinked thermoset network that resists flow and chars instead — with a stretch test to compare permanent deformation against elastic recovery.
Each chain in the tangle keeps its own covalent backbone regardless of the slider. At 0% crosslink density there is nothing holding different chains together, so heating them lets the chains slide past one another and sag into a puddle — a real thermoplastic melt. Add covalent crosslink bridges (amber bonds) between chains and the whole tangle becomes one connected 3D network: heat can no longer make it flow, so instead it slowly chars and darkens, which is what real thermosets do when overheated instead of melting.
Drag the crosslink density slider from 0% (thermoplastic) toward 100% (densely crosslinked thermoset) to add or remove covalent bridges between chains. Toggle Heat to raise thermal agitation and see the material either melt/flow or char depending on density. Run Stretch test to grip the network from both ends, pull it apart, release it, and read the live elastic-recovery percentage once it settles. Reset restores the original tangle without changing your crosslink density.
The molecular weight between crosslinks (Mc) — how much chain there is between each junction — directly sets a rubber's stiffness: fewer, sparser crosslinks give a soft, stretchy rubber band, while a densely crosslinked network like an epoxy resin barely stretches at all before it either recovers fully or fractures.