Magnetic Levitation: A Hands-On Exploration of Magnetic Forces

PSI is a spec sheet number, not what hits the wall

A pressure washer’s PSI rating describes the pressure the pump can build inside its hose and nozzle. What the grime on a driveway actually experiences is the impact pressure at the point of contact, which depends on that pump rating but is reshaped by everything the water passes through on its way there — the nozzle’s spray angle and, critically, how far the tip is held from the surface.

The three knobs that set impact pressure

Three variables combine to set what a surface actually feels:

Pump PSI higher pump pressure means higher jet velocity leaving the nozzle, before anything else changes it

Nozzle fan angle spreads the same flow over more area; a wide fan (25-40 deg) trades peak impact pressure for coverage, a narrow tip (0-15 deg) concentrates it into a point

Standoff distance jet velocity at the surface falls off with distance once past the coherent core, so impact pressure drops sharply the further back you hold the wand

Every one of these can be adjusted without touching the pump, which is why the same 3000 PSI washer can gently rinse pollen off siding with a wide fan held at arm's length, or gouge a groove into softwood with a narrow tip held close.

Pump PSI          higher pump pressure means higher jet velocity leaving
                  the nozzle, before anything else changes it

Nozzle fan angle  spreads the same flow over more area; a wide fan
                  (25-40 deg) trades peak impact pressure for coverage,
                  a narrow tip (0-15 deg) concentrates it into a point

Standoff distance jet velocity at the surface falls off with distance
                  once past the coherent core, so impact pressure drops
                  sharply the further back you hold the wand

Matching pressure to the material

Every material has an approximate impact-pressure threshold above which the surface itself starts to erode rather than just the grime on top of it. Dense cured concrete tolerates very high impact pressure, which is why driveway surface cleaners run 3000 PSI or more at close range. Softwood decking, vinyl siding and old mortar joints have a much lower threshold — push past it and the jet does not just remove dirt, it strips wood fibres, drives water behind siding panels, or blasts mortar out of brick joints. Professional cleaners keep a mental (or literal) table of safe PSI ranges by material for exactly this reason, and default to the widest fan angle and greatest standoff distance that still gets the job done.

Etching: the visible sign of exceeding the threshold

When impact pressure exceeds a material’s tolerance, the damage shows up as etching — visible grooves, fuzzing on wood grain, or pitting on soft stone, tracing exactly the path the nozzle travelled. Because impact pressure depends on the square of jet velocity and falls off steeply with standoff distance, the line between effective cleaning and etching is often a matter of a few centimetres of wand distance or a few degrees of fan angle, not a completely different piece of equipment.

Часті запитання

Спробуйте наживо

Усе, що вище, працює прямо у вашому браузері — відкрийте Pressure Washer Cleaning Simulator і змінюйте параметри під час роботи. Нічого не встановлюється, нічого не завантажується на сервер, уся модель живе в одній вкладці.