Presets
Playback
Wind
Kite and bridle
Line
Camera
Layers
Quality
Model check
The science
What is modelled
A diamond kite (a 1.1 m long, 0.9 m wide sail with spine and cross spar) flown on a line from a hand-held reel. The kite is a rigid body in the vertical plane of the wind: it can move downwind and up or down and it can pitch. The line is an elastic string that only pulls. The wind blows along x, grows with height and gusts.
Equations
- Wind:
U(z) = U10 (z/10 m)α(power-law boundary layer, α about 0.14 over open grass) times1 + I g(t), where g is an Ornstein–Uhlenbeck process with unit variance and correlation time τ (a standard gust model); a weaker vertical component and an optional thermal updraft are added. - Angle of attack
αis the angle between the relative airflow and the sail chord. Thin-plate coefficients:CL = a sinα cosαwitha = 0.75 · 2π / (1 + 2/AR)and AR = 1.64, andCD = CD0 + CD90 sin²α + CL² / (π AR e)(parasitic, flat-plate and induced drag). - Forces:
L = ½ ρ V² S CL,D = ½ ρ V² S CD, weightm g. The centre of pressure moves from 0.25 chord (small α) to 0.5 chord (broadside), which sets the pitching moment. - Tail: a ribbon with bows gives a drag-only force at the trailing edge,
F = ½ ρ (CdA)tail |vrel| vrel. Because it trails behind the centre of gravity, it makes the kite weathercock into the wind (a restoring pitching moment). - Line:
T = k (|P − A| − L) + c vrwhen stretched, else 0, with the bridle (tow point P in front of the sail) transmitting the pull. The torque of T about the centre of gravity, together with the aerodynamic and tail moments, decides the flying angle. - Motion:
M dv/dt = Faero + Ftail + T + M gandI dω/dt = Σ torques, stepped at 960 Hz with a semi-implicit scheme.
Checks run in the page
- Line pendulum without air against the large-amplitude period formula.
- Terminal speed of the kite falling flat in still air against
sqrt(2 m g / (ρ S CD)). - Steady flight after 90 s of time stepping against a separate Newton solver that finds the root of the force and torque balance directly.
Honest simplifications
The model is planar: there is no rolling, yawing or sideways swing, and the kite never loops. Lift and drag coefficients are smooth thin-plate formulas, not measurements of a particular sail (billow is represented by a 0.75 factor and the bridle by a fixed tow-point geometry). The line is drawn with a sag that follows its weight and slackness but its mass does not enter the dynamics, and the tail ribbon is a visual chain that is driven by the same wind but does not push back except through the drag term above. Gust parameters are representative, not site data.
What to try
- Move the tow point towards the nose and the kite flies at a lower angle of attack with less pull; move it towards the tail and it climbs steeply with more pull.
- Set the tail to 0 m in gusts: the pitch swings wider and the kite is more likely to stall and dive.
- Raise the shear exponent: the wind at the kite grows faster with height, so a longer line gives more pull.
- Use the heavy kite preset: the lift barely exceeds the weight, and the line goes slack in lulls.
- Cut the line to see the kite in free flight.