Bentonite Activation and Drying - 3D Plant

Mix soda ash into wet bentonite, age it, dry it in a tray dryer, and watch the Na-for-Ca exchange and the Page drying curve.

Switch to 2D

Presets

Playback

Recipe and aging

Soda ash, water and the aging step before drying.

Dryer

Air temperature, speed, bed depth and humidity.

Camera

Quality

Layers

Model checks

The science

Activation: swapping calcium for sodium

Natural bentonite is mostly montmorillonite, a layered clay whose sheets carry a negative charge balanced by exchangeable cations. Calcium-rich (Ca) bentonite swells little. Mixing the wet clay with soda ash (sodium carbonate) exchanges the cations: Ca-clay + Na2CO3 → Na-clay + CaCO3↓. The calcium carbonate is nearly insoluble, which pulls the exchange to the right. The clay's cation exchange capacity (CEC, here 90 meq/100 g) caps how much sodium it can hold; soda ash supplies dose × 1000 / (M/2) meq per 100 g (two equivalents per mole, M = 105.99 g/mol), so 3 g gives about 57 meq. The model gains sodium by a second-order law dφ/dt = k (1 − φ)2 toward that limit, with k = kref exp[−Ea/R (1/T − 1/Tref)] and a factor that switches exchange off as the paste dries below about 5 % water. Free swell is an empirical straight line in the exchangeable-Na fraction, 6 to 34 mL per 2 g.

Drying: the Page equation

Thin-layer drying is described by the Page equation MR = (X − Xe)/(X0 − Xe) = exp(−k tn) with an Arrhenius rate k = A exp(−Ea/RT). Air velocity and bed depth enter through the usual empirical scalings (v0.4, depth−2). The equilibrium moisture Xe follows a modified Henderson isotherm for the air humidity and temperature. A drying clay also shrinks: with a solid density of 2.6 times water the volume goes as 1 + 2.6 X, which is how the trays thin out.

Honest simplifications: every constant (Page n and k, activation energies, the Henderson constants, the swell line, the 5 % and 30 % water limits for exchange, the overheating penalty above 120 C) is illustrative, chosen to give realistic orders of magnitude, not fitted to a particular clay or plant. The batch is one lumped, well-mixed bed at the air temperature; there is no heat-transfer lag, no gas-phase exchange and no particle-size distribution. The 2D companion solves the actual water diffusion inside a pellet and checks it against Crank's series. This is an educational process model, not a plant design tool.

What to try
  • Standard batch: exchangeable Na climbs during the 4 h of aging, keeps rising while the clay is still moist in the dryer, then freezes as the water drops under 5 %.
  • No aging step: the clay dries before the exchange finishes and the free swell is much lower - the reason plants age the mix.
  • Over-dosed, 7 g: the CEC saturates, extra soda ash stays unreacted and the swell stops improving (last graph).
  • Hot dryer, 140 C: faster to 10 % water, but the overheating penalty cuts the swell.
  • Thick bed, 15 mm: drying time grows with the square of the depth.
Loading Blender model...
Water content over time
Exchangeable sodium over time
Time to 10 % water against dryer temperature
Free swell against soda-ash dose
Made with 🟠 Blender · Three.js