Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
A screw classifier washes dirty sand. Slurry enters a pool in an inclined trough; water drifts toward a weir at the low end and carries the silt and clay away, while the sand settles onto the floor where a slowly turning screw lifts it up the slope, draining as it leaves the water. The coloured balls are sample parcels of equal mass drawn from the feed; brown ones are silt (under 75 micrometres), sand-coloured ones are sand.
Equations
- A suspended parcel is carried toward the weir by the flow,
dx/dt = −Qw / (W h(x)), and sinks,dz/dt = −wh, plus a random turbulent step√(2K dt). The floor rises aszf = x tanθso the depth ish = H − x tanθ. A parcel that reaches x = 0 leaves over the weir; one that reaches the floor joins the bed. - The still-water settling velocity of a grain is the Ferguson-Church law
w = R g d² / (18ν + √(0.75 R g d³))with R = ρs/ρ − 1 = 1.65, which reduces to Stokes' law for fine silt and to the Newton drag law for gravel. The viscosity ν(T) of water follows from the temperature. The dense slurry slows settling by the Richardson-Zaki factor(1 − C)4.65. - In a flat tank the cut is the Hazen overflow rate: a grain is kept only if
w > Q / A, with A the surface area. The model reports this rate and the cut size found by following a surface-fed grain through the sloping pool. - The screw lifts at
v = P n K(θ)and at mostC = ρb (π/4)(D² − ds²) P n ψ K(θ)(pitch P, speed n, fill ψ = 0.35, inclination factor K = 1 − 0.0175θ). A parcel that lands on the floor while the screw is full is flushed out with the overflow.
Model checks
- Settling velocity against the Stokes and Newton limits and textbook values for sand; viscosity of water at 20 C.
- A flat tank, without turbulence or hindering, must catch a grain at 1.1 times the Hazen settling speed and lose it at 0.9 times.
- Parcels fed = product + overflow + parcels still inside, and the sampled feed has the requested silt share.
- The capacity formula against a numerical annulus integral, the lift time against length divided by speed, and the flux limit when the screw is overloaded.
Simplifications, stated plainly
- The pool is a two-dimensional vertical section with a uniform horizontal velocity at each depth. Real pools have inlet jets, recirculation and short-circuiting that move the cut by tens of percent. Turbulence is a single constant diffusivity.
- Hindered settling uses half the feed solids concentration as the pool average, a rough guess; flocculation of clay, grain shape and dispersion are not modelled. Quartz density and a fixed viscosity law are assumed.
- The screw is a perfect conveyor with a flat-capacity formula and a typical inclination factor; slip, backflow through the clearance and sand falling back down the slope are ignored, and the washing water spray only appears as the overflow rate.
- The silt gradation and the sand gradation are log-normal and chosen for illustration. Treat numbers as a way to compare settings, not as a plant design.
What to try
- Raise the overflow water: the cut size moves to coarser sand and the product gets cleaner but you lose fine sand. Lower it and silt stays in the product.
- Choose Screw too slow: overload, where the lifting capacity is below the sand arriving and the extra is flushed to the pond.
- Try cold water: viscosity rises, grains settle more slowly and the cut shifts coarser.
Loading model...
Loading Blender model...