Antenna and radio waves

A dipole transmitter and a tuned whip receiver: wavelength, radiation pattern, resonance and the inverse-square link.

Switch to 2D

Presets

Playback

Transmitter

Receiver whip

Camera

Layers

Quality

Model check

The science

What is modelled

A vertical thin-wire dipole of length L is fed at its centre at a height of 4.4 m. A whip antenna of adjustable length sits on a radio 25 m away and is tilted by hand. The transmitter radiates the power you set; the receiver collects part of it. The ground slice, the green pattern surface, the LEDs and all graphs come from the same formulas.

Equations

  • Wavelength: λ = c / f, wave number k = 2π/λ. The animation is slowed by a factor of about 108; the spacing of the wave fronts is the true wavelength.
  • Current on a thin centre-fed wire (standing wave): I(z) = I0 sin[k(L/2 - |z|)].
  • Far field: Eθ = j η I0 e-jkr F(θ) / (2π r) with F(θ) = [cos(kL/2 cosθ) - cos(kL/2)] / sinθ and η = 376.73 Ω. For L = λ/2 this is the familiar cos(π/2 cosθ)/sinθ.
  • Radiated power and radiation resistance (referred to the current antinode): Rr = (η/2π) ∫0π F2 sinθ dθ; directivity D = 2 Fmax2 / ∫ F2 sinθ dθ (1.64 = 2.15 dBi for a half-wave dipole). Input resistance at the feed: Rin = Rr / sin2(kL/2).
  • Reactance (transmission-line approximation of a thin dipole): Xin = -Zc cot(kL/2) with Zc = 120 (ln(L/a) - 1), wire radius a = 3 mm. It is zero at L = λ/2 (resonance), negative (capacitive) for a shorter whip.
  • Link (Friis): Pr = Pt Gt(θt) Gr(θr) · PLF · q · (λ / 4πd)2, where G = D F2(θ)/Fmax2, PLF is the polarisation factor (squared cosine between the field and the whip projected on the wave front) and q = 4 Rin RL / [(Rin + RL)2 + X2] is the impedance-mismatch factor for a 50 Ω receiver.
  • Effective length of the whip (receive): leff = ∫ I dz / Iin = (2/k) tan(kL/4), and effective aperture Ae = η leff2 / (4 Rin) = λ2 D / 4π (reciprocity).

Checks run in the page

  • Half-wave dipole: Rr = 73.1 Ω and D = 1.64 from numerical integration against textbook values; short dipole limit Rin = 20π2(L/λ)2.
  • Power conservation: the gain integrated over the whole sphere equals 4π for the transmitter length you chose.
  • Reciprocity: the aperture from the circuit (integrating the current numerically) equals the aperture from the directivity, for the whip length you chose.
  • Received power by two independent routes: the Friis formula and field strength to open-circuit voltage to a 50 Ω load.

Honest simplifications

  • Thin wire with an assumed sinusoidal current. A real antenna has a slightly different current (finite thickness, end effects), which shifts the resonant length a few percent shorter than λ/2 and changes the reactance; the cot(kL/2) formula is only reliable near resonance.
  • Free space: no ground reflection, no multipath, no obstacles. Real VHF links have ground reflections that cause deep interference notches with distance and height.
  • The transmitter is assumed lossless and perfectly matched, so all of Pt is radiated. The receiver is a 50 Ω resistor with no matching network; the -90 dBm noise floor and the six signal bars are illustrative values, not those of a specific radio.
  • The wave-front slice shows the far-field expression everywhere; it is not valid within about one wavelength of the antenna (near fields are not modelled).

What to try

  • Drag the whip length: power peaks near λ/2 and again near 1.5 λ with a deep dip at λ (anti-resonance).
  • Tilt the whip sideways to 90 degrees: it lies across the electric field and receives nothing. Tilt it toward the mast: it points along the line of sight, into its own pattern null.
  • Set the transmitter to 1.5 λ and watch the pattern split into lobes; the receiver may then sit in a null.
  • Double the distance: power falls by 6 dB (inverse square).
Loading model...
Loading Blender model...
Transmitter pattern (polar)
Received power vs whip length
Received power vs distance
Made with 🟠 Blender · Three.js