3D Printer: Printing a Vase, Melt Limit, Cornering and Layer Cooling

An FDM printer in a Blender-built workshop draws a vase layer by layer: motion planning, the hot-end flow limit and cooling of each layer.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

A fused-filament printer builds a vase in "vase mode": two solid base layers laid in a spiral from the centre outwards, then one continuous spiral wall that rises by one layer height per turn. The page works out the whole tool path first, then runs the print along it. Three limits are modelled: how fast the head can really move round the curve (acceleration), how much plastic the hot end can melt per second (so a line gets thinner if you ask for too much), and how fast each new strand cools, because the layer below must be nearly solid when the next one lands on it. The printer, bed, gantry, spool, extruder and desk are Blender-built models; the printed vase is generated from the path and appears as the nozzle draws it.

Equations

  • Cornering: on a curve of radius r the head can move at most v ≤ √(a r), so small radii (the centre of the base, a narrow neck) run slower than the set speed v. A straight move of length d with acceleration a takes t = d/v + v/a (or 2√(d/a) if it never reaches v).
  • Volumetric flow: Q = w h v (line width, layer height, speed). The filament is fed at vf = Q/Af with Af = π(0.875 mm)².
  • Melt limit: the heater can bring plastic from room temperature to the nozzle temperature at Qmax = η P / (ρ c (Tn − Ta)) with ρ = 1240 kg/m³, c = 1800 J/kg K and η the share of the heater power that reaches the plastic. If Q > Qmax the line is thinner by the factor Qmax/Q.
  • Cooling of a strand as a lumped body: T(t) = Ta + (Tn − Ta) e−t/τ, τ = ρ c (w h/(w + h)) / heff. The turn time at a given height is the time between two passes over the same spot, and the layer below is at T(tturn) when it is covered. Glass transition of PLA: about 60 C.

Checks run in the page

  • Stepped trapezoid move against the closed-form time (long and short move).
  • Wall filament length of the plan against the Simpson integral of the radius profile.
  • Stepped strand cooling against the exponential.

Honest simplifications

The effective heat-transfer coefficient lumps convection, radiation and conduction into the part, and the share of heater power that melts plastic is a stand-in for the real heat flow through the heat break; both are round, typical values. Acceleration is applied only through the curve limit and straight-move formula, not a full look-ahead planner with jerk or junction deviation. The extruder is assumed to follow the commanded flow exactly up to the melt limit (no pressure advance, no ooze). Warping, bed adhesion, stringing and the exact bead cross-section are not modelled; the bead is drawn as a rounded line of the commanded width and height.

What to try

  • Choose the small tall tower without the fan and watch the red layers appear: the layer time is shorter than the cooling time. Then use the 100 % fan preset.
  • Raise the print speed above the limit shown in the readout: the lines become thin and dark.
  • Lower the acceleration and see the print time grow, mostly in the tight curves.
  • Follow the nozzle for a close view of the layers.
Loading model...
Loading Blender model...
Layer time vs height
Temperature of the layer below
Flow demand vs speed
Made with 🟠 Blender · Three.js