3D Golf Ball Dimple Aerodynamics

Smooth against dimpled ball: drag crisis, wake size and carry distance, with Blender-built balls and a Reynolds-number-based drag model.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

Two identical golf balls, one smooth and one with 332 dimples, sit in the same air stream and then fly the same shot. The balls in the picture are enlarged about 23 times and the downrange scale is 1 scene unit = 5 m, so the flight path is drawn with true proportions between distance and height.

The equations

  • Reynolds number Re = ρ U D / μ with D = 42.67 mm and μ = 1.81×10-5 Pa s.
  • Drag Fd = ½ ρ A Cd(Re) U2, A = π D2/4. A smooth sphere sits near Cd = 0.47 until the boundary layer turns turbulent at Re of about 3×105. Dimples trip it at Re of about 5×104, so a dimpled ball is already past this drag crisis at ordinary golf speeds and has Cd of about 0.25.
  • Magnus lift L = ½ ρ A CL U2, with CL = 0.54 S0.4 capped at 0.35 and spin ratio S = ω R / U, acting perpendicular to the airflow.
  • Flight: m dv/dt = m g + Fd + L integrated with fourth-order Runge-Kutta in the vertical plane, headwind added to the air velocity.

Checks run in the page

  • With drag and lift switched off the integrator reproduces the vacuum range v² sin2α / g and apex v² sin²α / 2g to 0.1 %.
  • Work-energy theorem: kinetic energy lost by the dimpled ball equals the integral of Fd·v dt.
  • Terminal speed of a dropped ball: integrated value against the force balance m g = Fd solved by bisection.

Honest simplifications

The Cd(Re) curves are smooth fits to the shape of published wind-tunnel results (for example Bearman and Harvey, 1976), not measurements of one particular ball. Spin is held constant during the flight although real spin decays by a few percent per second, lift is the same formula for both balls, and there is no crosswind and no roll after landing. The wake cones and streamlines are an illustration of the separation angle, not a CFD solution; the separation angle is mapped linearly from Cd. The balls, tees, plinths, nozzles and distance markers are Blender-built models; the dimples are real geometry.

What to try

  • Drop the speed to 20 m/s: the dimpled ball is in the middle of its drag crisis and the advantage shrinks.
  • Set spin to zero and compare carry: lift accounts for much of the gain of a real drive.
  • Use the Denver preset: thinner air lowers drag and lengthens the carry of both balls.
  • Use the Ball close-up camera to see the dimples as geometry.
Loading model...
Loading Blender model...
Drag coefficient vs Reynolds number
Flight paths
Carry vs launch speed
Made with 🟠 Blender · Three.js