loading...
running...
The science
The comb is a row of tuned cantilevers. A steel tooth of length L, thickness t, Young's modulus E and density ρ is an Euler-Bernoulli beam clamped at one end. Its mode shapes satisfy cos(β)cosh(β) + 1 = 0, with roots β1 = 1.8751 and β2 = 4.6941, so the first-mode frequency is
f1 = (β12 / 2π) · (t / L2) · √(E / 12ρ), f2/f1 = (β2/β1)2 = 6.267
Pitch goes as 1/L2: to double the frequency the tooth is made 1/√2 as long, and the graph "tooth length against frequency" shows the 1/√f curve with the 16 design teeth on it. Raising the comb thickness raises every note by 1200·log2(t/t0) cents, which the Thickness slider and the red dots show. With t = 0.45 mm the model gives teeth between 37.5 mm (C4) and 17.7 mm (D6).
Plucking. Each pin presses its tooth down by the pin lift and then lets go. After release the tip follows a damped oscillation with damping ratio ζ = 1/(2Q):
x(t) = A e-ζωt [ 0.94 cos(ωt) + 0.06 e-0.3ζω(r2-1)t cos(r2ωt) ], ω = 2πf1, r2 = (β2/β1)2
(the 6 % second-mode share is a model choice). Real vibration is far too fast to see, so the picture slows the oscillation phase by the Slow-motion factor; the sound is not slowed.
Spring, gear train and governor. The spring torque falls linearly as it unwinds, τs = τ0·(turns left)/(turns wound). A chain of three meshes (A 60 → B1 10, B2 48 → C1 8, C2 40 → D 8) multiplies the speed by R = (60/10)(48/8)(40/8) = 180, so the air vane runs at 180 times the cylinder speed. Vane drag torque grows as the square of its speed; referred back to the cylinder shaft it is cω2, where c scales with the vane area. With I the reflected inertia and τf the bearing friction:
I dω/dt = τs - τf - cω2, ωterminal = √((τs - τf) / c)
This is why the tempo is steady but sags slowly as the spring runs down (ω goes as the square root of torque), and why a bigger vane slows the music. The energy the spring releases equals the heat lost in the vane and bearings plus the kinetic energy of the rotor.
Checks (run in the page). (1) the root of cos x cosh x + 1 = 0 found by bisection against the stored β1; (2) the ratio of the two roots; (3) an RK4 integration of the tooth oscillator against 1/f from beam theory; (4) the simulated terminal speed against √((τ-τf)/c); (5) the energy balance over 40 s; (6) the gear ratio counted tooth by tooth.
Simplifications. Each tooth is a single-mode oscillator plus a fixed share of mode 2; coupling through the comb base, the pin geometry (the pluck is a ramp then release) and the soundboard are ignored; the governor is a vane with pure quadratic drag and a fixed reflected inertia; the spring is linear. The melody is a 32-step cylinder.