Side-on view of a platform dive: choose height, spin and shape, see stroboscopic poses, the conserved angular momentum, the entry angle and the lung volume under pressure.
The science
A platform dive is three separate physics problems glued together: a projectile in the air, a rotating body whose spin rate changes with its shape, and a body decelerating in water where pressure rises with depth.
Flight
The centre of mass follows y = y0 + v0t − ½gt², x = x0 + vxt, with a small quadratic air drag ½ρairCdA v² (CdA about 0.45 m², an estimate; switch it off to compare with the textbook parabola). The flight time from height H is t = (v0 + √(v0² + 2gH))/g.
Rotation
Once the diver leaves the board nothing can change the angular momentum L = Iω about the centre of mass. The diver changes I by moving limbs: a six-segment body model (trunk, head, thighs, shanks, upper arms, forearms; masses and lengths from standard anthropometric fractions) gives I = Σ mi(li²/12 + di²) for each pose, so a tuck (about 3.6 kg m²) spins roughly four times faster than a straight body (about 14 kg m²). Opening out slows the spin so the diver can aim at a vertical entry.
Water entry and depth
Entry is detected when the lowest body point reaches the surface. Below the surface (m + ma) dv/dt = −mg + ρwgVsub − ½ρwCdAeff|v|v, with added mass ma = 0.15ρwV. A head-first entry presents about 0.045 m²; a flat entry or the pull-out flare presents about 0.2-0.3 m² and stops the diver far faster (this is also why a flat entry is painful). Without flaring, a 10 m dive would reach the floor of a normal pool.
Boyle's law
Pressure grows p = patm + ρwgd, about 1 atm per 10.3 m. Air in the lungs obeys pV = const, so 4.5 L at the surface is 3.0 L at 5 m and 2.2 L at 10 m. That shrinking volume slightly reduces buoyancy as the diver goes down and is the reason a scuba diver must never hold their breath while ascending.
Honest simplifications
The body is a planar chain (somersault axis only: no twist); the pose changes are scripted, not muscle-driven; the take-off is reduced to initial velocity and angular momentum; water entry uses a quasi-steady drag with an immersion-fraction ramp, not a free-surface fluid simulation; the splash is a visual effect scaled by entry speed and flatness, not computed. The judge score is only an entry-angle proxy (10 minus 1 point per 6 degrees), not the real FINA scoring.
2D twin: the same simulation core as the 3D engine, shown as a side-view stick figure with stroboscopic ghosts and a live L = Iω readout.