Plan and side views of a 1.4 km ice track: run a four-man or two-man sled, colour the track by speed and watch the wall angle and g-load in a live cross-section.
The science
The sled is a point mass sliding along a fixed curve (the track centre line), so the problem reduces to one equation along the path: gravity pulls it down the slope, friction and air drag oppose it.
Equation of motion
m dv/dt = m g sinα − μ N − ½ρ CdA v², with the normal force N = m √((g cosα)² + (v²/R)²). In a corner the track must also push the sled sideways, so N is larger than the weight; this extra load, in g, is what the crew feels (3-4 g here, in line with the 4-5 g quoted for real tracks). Because friction is proportional to N, fast corners cost speed.
Banking and the wall
On a smooth U-shaped track the sled rides up the wall until the wall is perpendicular to the resultant of gravity and centripetal force: tanβ = v²/(gR cosα). At v = √(gR tanβ) the load is exactly 1/cosβ (one of the checks). The model flags a crash when the required angle passes 78 degrees (the wall top), i.e. v > √(gR tan 78°).
Driving line
Taking a tighter line reduces the radius of the arc the sled actually follows: path length per corner is (R − line) × deflection, but the load goes up as 1/R. The track here is a generic 1.4 km training track with nine corners and about 150 m of drop, not a copy of any real venue.
Friction and ice
Steel on ice has a coefficient of about 0.01-0.02 thanks to a thin meltwater film. The ice-temperature scaling (μ × (1 + 0.004(T + 9)²), best near −9 °C) is a rough illustrative curve, not measured data. Air density comes from the ideal-gas law at 101.3 kPa.
Honest simplifications
One-dimensional path model: no steering, no skidding, no yaw dynamics or wall contact forces, no change of CdA with the crew's posture, no push-start phase (the run begins at the speed you set). The 3D sled pose is derived from the same banking physics but is only a visualisation. The integrator is 4th-order Runge-Kutta with a 5 ms step.
2D twin: same path model and RK4 integrator as the 3D engine, shown as a speed-coloured plan view, a side elevation profile and a live cross-section of the banked wall.