Carve: draw the knife across the soap. Smooth: rub the surface with a damp thumb. Turn bar: drag sideways to spin the bar on its dish. Outside the soap, dragging always orbits the camera.
running...
The science
Volume by integration. The soap is a signed-distance field f(x) on a 0.1 cm grid (f < 0 inside). A voxel that the surface crosses is only partly filled, so the volume is the sum of the filled fractions:
V = h3 Σ clamp(1/2 − fi/h, 0, 1) → ∫f<0 dV as h → 0
Density and mass. Mass is m = ρV; a typical bar soap has ρ of about 1.0–1.1 g/cm3 (sodium soaps with a little water and glycerin). Because ρ is uniform here, the mass removed is simply
mremoved = ρ (V0 − V)
Carving as set subtraction. The knife is a ball of radius r (half the contact width) pressed to a depth d below the surface the stroke started on: f ← max(f, r − |x − c|). Each pass is limited to the surface that existed when the stroke began, which is why one stroke removes a layer of thickness at most d, as with a real draw knife.
Hardness and force. Mohs numbers are an ordinal ranking, not a linear scale, so the model uses an illustrative cutting stress σ(H) = 0.15 MPa × 1.7H−1. The force needed to cut a groove of width w and depth d is F = σ w d; with a hand-force limit Fmax the achievable depth is d = min(dset, Fmax/(σ w)). Real soap is a viscoelastic, rate-dependent paste of crystalline fibres; this is the simplest consistent description, not a measured law.
Shavings. Removed volume is converted into curls (each with its exact share of the volume, so the mass books balance) that fall with y″ = −g − k y′ (g = 981 cm/s2, k a small air-drag rate), bounce a little on the soap, the dish and the bench, and come to rest. The drawn curl size is only a visual proxy for the volume it carries.
Checks run in the page. (1) the voxel volume of the fresh bar against the closed-form rounded-box volume; (2) a carved sphere against 4πR3/3; (3) a mass ledger: summed local volume changes of many random cuts and smoothings against the global integral V0 − V; (4) the shaving integrator against free fall t = √(2h/g); (5) after you carve, the removed volume against the volume held by the shavings.
Honest simplifications. Soap is uniform and isotropic here; there is no plastic flow, no heat from cutting and no real chip-formation mechanics. The signed-distance field after many cuts is no longer an exact distance, so the volume has a small sub-voxel error (the checks bound it near 0.5%). Models were built in Blender 5.2 with baked textures; the soap itself is generated live.