Pottery Wheel: Throwing a Vessel, Spin Momentum, Centrifugal Limit and Wall Buckling

Throw a vase from a lump of wet clay on a Blender-built electric wheel: set speed, shape and clay and read the wall, the angular momentum and whether it flies apart or buckles.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is simulated

A fixed mass of wet clay is thrown on an electric potter's wheel: a solid lump is opened and pulled up into a vessel. The page follows the shape through the throw, computes the moment of inertia of the clay, runs the wheel with a speed controller, and checks the two things that ruin a pot: the clay flying outward when the wheel is too fast for the vessel's width, and a tall thin wall buckling under its own weight and the potter's hand.

Shape and volume

The outer wall is ro(s) = R + b sin(πs) − d s with s = z/h: base radius R, belly b, taper d. The clay never changes volume (V = m/ρ, ρ = 1900 kg/m3), so the wall thickness t follows from V = ∫ π[ro2 − max(ro − t, 0)2] dz plus a 12 mm floor: the taller or wider the vessel, the thinner the wall.

Spin and angular momentum

The wheel obeys d(Iω)/dt = τmotor − τbearing − τhand with I = Iwheel + Iclay(p). A PI controller drives the motor (limited to 6 N m and 400 W) toward the set speed; bearing friction is 0.04 + 0.0004ω N m and the hand drag is 0.3 F r. With the motor off the product Iω is conserved: pulling the clay outward raises I and slows the wheel, which is why heavy flywheels are used.

Centrifugal limit and wall buckling

A free ring of clay at radius r spinning at ω carries the hoop stress σ = ρ ω2 r2; it holds while this stays below the tensile strength of wet clay, which gives ωmax = √(σt/ρ)/r. The wall also has to carry its own weight ρ g h plus the hand load F/(2π r t) without buckling; the classical thin-cylinder value E t / (r √(3(1−ν2))) is reduced by a knockdown factor of 0.3, as for real shells.

Simplifications

  • The shape is given by three numbers and a smooth morph from the lump; the potter's hands do not shape the clay in the simulation, they only add a friction torque and an axial load.
  • The ring model for the centrifugal limit is conservative: in a real vessel the belly is supported by the rest of the shell. The values for wet-clay strength (2 to 8 kPa), modulus (0.4 MPa) and the knockdown factor are round figures of the right order, not measurements of a given clay body.
  • The wall thickness is horizontal and uniform above the 12 mm floor; slip, water, wobble from an uncentred lump and clay viscosity are not modelled.
  • Where the limits are exceeded the 3D clay is drawn flaring or slumping as a warning; it does not simulate the failure.

Checks

Five boxes: the clay volume from an exact revolved integration of the drawn cross-section against the mass over the density; the sliced moment of inertia of a hollow cylinder against the closed form; conservation of Iω through a whole throw with the motor off; the ring stress from adding up centrifugal forces on half a ring against ρ ω2 r2; and a motor spin-up integrated with RK4 against the exponential solution.

Loading model...
Loading Blender model...
Moment of inertia against throw progress
Wheel speed, last 60 s
Centrifugal speed limit against vessel radius
Made with 🟠 Blender · Three.js