Experiment 01 · Measurement & uncertainty
Measure the acceleration due to gravity
Build a simple pendulum, predict the result, then collect six measurements and fit a straight line. The stopwatch and ruler include repeatable, seeded measurement noise.
Experiment seed 731604 · Intermediate
3D laboratory bench · SI scale
Drag the bob onto the blue socket to connect the pendulum
Brass bob
Connection socket
Steel apparatus
Measuring ruler
Apparatus assemblyBob not connected
Drag the brass bob from the bench tray onto the blue eyelet at the end of the string. After connecting, drag the bob to adjust the live pendulum length. The ruler and stopwatch can also be repositioned.
The science · equations, assumptions & honest simplifications
Model and equations
T = 2π √(L / g)
T² = (4π² / g)L
g = 4π² / gradient
The simulation integrates θ̈ = −(g/L) sin θ using a fourth-order Runge–Kutta method and a fixed 1/120 s step. The graph uses a least-squares straight-line fit to measured T² and L.
Assumptions
- The string is light, taut and inextensible.
- The bob is treated as a point mass at its centre.
- The pivot is fixed and the swing stays in one plane.
- The reference model uses g = 9.80665 m/s².
- The initial angle is small: 0.04 rad (about 2.3°).
Noise and limitations
- Length readings are rounded to 1 mm; the random component is seeded and repeatable.
- Each stopwatch interval has 0.05 s reaction-time standard uncertainty and 0.01 s display resolution.
- Three repeats of ten oscillations reduce timing scatter.
- Friction and air drag are represented by small effective period shifts, not a full fluid or bearing model.
- Parallax is a +3 mm systematic length bias. Heat loss is not included because this is a mechanical, not thermal, experiment.
- The displayed fit uncertainty is a conservative 4× regression standard error; it is pedagogical, not a certified calibration uncertainty.