Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
1. Rain into the soil. The soil mantle (slope-normal thickness T) lies on impermeable bedrock. The pore pressure head psi(Z, t) follows the linearised Richards equation of Iverson (2000): d psi/dt = D0 d2 psi/dZ2, starting from a hydrostatic profile psi = cos^2(beta) (Z - d) with the water table at depth d. Rain enters as a flux condition d psi/dZ = cos^2(beta) - I/Ks at the surface (rain that exceeds what the soil can take, psi > 0 at the surface, runs off); there is no flow through the bedrock. The equation is solved by Crank-Nicolson on 60 nodes and checked against the closed form (I/Ks) 2 sqrt(D0 t) ierfc(Z / 2 sqrt(D0 t)).
2. Will it fail? The infinite-slope safety factor with pore pressure is FS = tan(phi')/tan(beta) + (c' - psi gamma_w tan(phi')) / (gamma_s Z sin(beta) cos(beta)). For a dry cohesionless slope FS = tan(phi')/tan(beta), so it fails exactly at beta = phi'; full seepage parallel to the slope gives (1 - gamma_w/gamma_sat) tan(phi')/tan(beta), about half of that. The slab fails when FS drops below 1 at the soil-bedrock contact.
3. Where does it go? The released slab (length Lf) flows as a depth-averaged Savage-Hutter layer along the ground profile: dh/dt + d(hu)/ds = 0 and d(hu)/dt + d(h u^2 + K g cos(theta) h^2/2)/ds = h g sin(theta) - mu_eff h (g cos(theta) + kappa u^2) sign(u), with kappa the curvature of the ground. The basal friction is Coulomb, mu_eff = tan(delta) (1 - r lambda), where lambda is the pore-pressure ratio at failure and r is the fraction retained in the flow, a free parameter. Finite volumes with Rusanov fluxes conserve the mass to rounding error.
Simplifications. Infinite-slope theory gives no failure length: the slab length is an input. The failure plane is fixed at the soil-bedrock contact. Matric suction (negative psi) is ignored (conservative). Uniform soil, one rain intensity, no vegetation or root dynamics. The flow is 1-D (no lateral spreading), the earth-pressure coefficient is fixed at K = 0.6, and entrainment of the soil below the slope is not modelled. The debris pile is therefore a first estimate of runout for teaching, not a hazard map. Boulders are drawn for visual effect and ride the computed flow velocity.
Numerical checks in the page: the two safety-factor identities, the pore-pressure solution against the closed form, the acceleration of a uniform slab, the Coulomb deceleration on a flat bed (all with mass conservation), and the Blender asset sizes.