Rainfall Landslide: Pore Pressure, Safety Factor and Debris Runout

Rain soaks a soil mantle on a hillside until the safety factor drops below 1; the slab then slides as a granular flow towards a house on the plain below.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

1. Rain into the soil. The soil mantle (slope-normal thickness T) lies on impermeable bedrock. The pore pressure head psi(Z, t) follows the linearised Richards equation of Iverson (2000): d psi/dt = D0 d2 psi/dZ2, starting from a hydrostatic profile psi = cos^2(beta) (Z - d) with the water table at depth d. Rain enters as a flux condition d psi/dZ = cos^2(beta) - I/Ks at the surface (rain that exceeds what the soil can take, psi > 0 at the surface, runs off); there is no flow through the bedrock. The equation is solved by Crank-Nicolson on 60 nodes and checked against the closed form (I/Ks) 2 sqrt(D0 t) ierfc(Z / 2 sqrt(D0 t)).

2. Will it fail? The infinite-slope safety factor with pore pressure is FS = tan(phi')/tan(beta) + (c' - psi gamma_w tan(phi')) / (gamma_s Z sin(beta) cos(beta)). For a dry cohesionless slope FS = tan(phi')/tan(beta), so it fails exactly at beta = phi'; full seepage parallel to the slope gives (1 - gamma_w/gamma_sat) tan(phi')/tan(beta), about half of that. The slab fails when FS drops below 1 at the soil-bedrock contact.

3. Where does it go? The released slab (length Lf) flows as a depth-averaged Savage-Hutter layer along the ground profile: dh/dt + d(hu)/ds = 0 and d(hu)/dt + d(h u^2 + K g cos(theta) h^2/2)/ds = h g sin(theta) - mu_eff h (g cos(theta) + kappa u^2) sign(u), with kappa the curvature of the ground. The basal friction is Coulomb, mu_eff = tan(delta) (1 - r lambda), where lambda is the pore-pressure ratio at failure and r is the fraction retained in the flow, a free parameter. Finite volumes with Rusanov fluxes conserve the mass to rounding error.

Simplifications. Infinite-slope theory gives no failure length: the slab length is an input. The failure plane is fixed at the soil-bedrock contact. Matric suction (negative psi) is ignored (conservative). Uniform soil, one rain intensity, no vegetation or root dynamics. The flow is 1-D (no lateral spreading), the earth-pressure coefficient is fixed at K = 0.6, and entrainment of the soil below the slope is not modelled. The debris pile is therefore a first estimate of runout for teaching, not a hazard map. Boulders are drawn for visual effect and ride the computed flow velocity.

Numerical checks in the page: the two safety-factor identities, the pore-pressure solution against the closed form, the acceleration of a uniform slab, the Coulomb deceleration on a flat bed (all with mass conservation), and the Blender asset sizes.

Loading model...
Loading Blender model...
Safety factor at the soil base against time
Pore pressure profiles through the soil
Ground profile, soil and debris
Made with 🟠 Blender · Three.js