HPGR Pressure Zone: Roll Press Nip, Compaction and Specific Force

Watch a bed of ore pulled between two Blender-modelled grinding rolls: the nip angle, the pressure peak at the gap, the roll force and the throughput all follow from one mass balance and a compaction law.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What an HPGR does. A high-pressure grinding roll press feeds crushed ore between two counter-rotating rolls, one of them floating on hydraulic cylinders. The bed is squeezed at 50 to 200 MPa so that the particles crack against each other (inter-particle comminution) and leave as a dense, micro-cracked flake. The region where the bed is compressed is the pressure zone (nip).

Geometry and mass balance. With roll diameter D and operating gap S, the gap at angle theta above the line of centres is h = S + D (1 - cos theta). If the material moves with the roll surface its vertical speed is u cos(theta), so conservation of mass gives rho h u cos(theta) = rho_g S u, with flake density rho_g. The bed is gripped at the nip angle alpha where its density is still the feed bulk density: h(alpha) cos(alpha) = r S, with r = rho_g / rho_b. Above alpha the feed moves as a loose bulk: its speed follows the same mass balance, u r S / h, so it accelerates into the nip.

Pressure and force. The bed is compressed along a power law sigma = P0 (rho / rho_b)^K, the form used by roll-compaction theory (Johanson 1965) and by HPGR models. The roll force follows by integrating the pressure over the contact arc: F = L (D/2) integral of sigma cos(theta) d theta from 0 to alpha, and the specific force is F / (D L), the number HPGR operators quote in N/mm2. Throughput is Q = u L S rho_g; the operating-gap model of Morrell and Torres uses the same relation with a measured flake density. The ideal compaction work per kilogram, P0 (r^(K-1) - 1) / (rho_b (K - 1)), is the energy needed to squeeze the bed from rho_b to rho_g without shear or elastic loss.

What is simplified. The bed is a continuum with one power law; real ore has a size distribution, moisture, a slip zone near the entry, edge effects (the pressure falls towards the cheek plates) and elastic recovery that makes the flake thicker than the gap. The no-slip assumption makes the speed at the roll surface equal the bed speed; the gap, P0, K and r are inputs, not predicted, and the default values are illustrative, chosen so that the specific force (about 4 N/mm2), power and throughput fall in the range of industrial machines (a roll of 1.7 m diameter and 1.0 m width). The drive power shown is only the ideal compaction work times the mass flow, so it is a lower bound. The coloured pieces are tracers that stand for equal shares of the mass flow, not individual ore particles; the cheek plate on the viewer side is hidden so that the nip can be seen. This is an educational model, not a design tool.

Numerical checks (run on load): a closed form for a pressure-independent bed, the small-gap limit of the nip angle, a 45-second tracer run that must conserve the mass flow and reproduce the density law, the compaction work by direct integration, and the roll geometry measured from the Blender meshes.

Loading model...
Loading Blender model...
Pressure along the pressure zone
Density of the bed above the gap
Throughput and specific force against operating gap
Made with 🟠 Blender · Three.js