Elbow flexion is a lever problem. The load torque about the elbow is τload = (mw L + mf dcm) g sinθ, where θ is the forearm angle from hanging straight down: zero at the bottom, largest when the forearm is horizontal. Rep speed adds an inertial term Iα, which is why a fast "swing" lets a heavier weight past the hard spot.
The muscle torque is τm = Fmax f(ℓ) r(φ). Moment arm from the geometry of origin and insertion (distances b and a from the elbow, joint angle φ): ℓ² = a² + b² - 2ab cosφ, r = a b sinφ / ℓ + r0, where r0 = 1.2 cm is an assumed fixed offset for tendon wrapping (the pure geometric formula would give zero moment arm at a straight arm, which is not realistic). Reps start at 15 deg flexion (no lock-out). The force-length factor f is a bell curve peaking at φ = 100 deg. Where the curve of load torque rises above the capacity curve, the lift sticks. This is a "load curve" in training language.
Each completed rep multiplies the force capacity by (1 - fatigue%), a simple illustrative model; real fatigue depends on rep speed, rest and fibre type.
Simplifications: one lumped elbow-flexor muscle (a = 5 cm, b = 28 cm, Fmax = 1400 N is a "typical order of magnitude", not an individual's value), upper arm held vertical, forearm mass 1.5 kg, no shoulder motion, muscle force-velocity effect ignored. Educational only, not a training plan.