Chladni Vibration Patterns (2D)

Sand gathers on the nodal lines of a driven square plate: modes (m,n)+/-, resonance sweep and friction.

Presets

Playback

Plate

Drive

Sand

Layers

Model check

The science

What a Chladni figure is

Sand on a vibrating plate is thrown off wherever the plate moves strongly and stays where it hardly moves. A plate driven near one of its resonances vibrates in a standing-wave pattern, and the sand collects on the nodal lines where the displacement u(x,y) is zero.

Plate equation and frequencies

A thin elastic plate obeys D ∇4u + ρh ∂2u/∂t2 = 0 with bending stiffness D = E h3 / (12(1 - ν2)). A standing wave u = φ(x,y) cos ωt needs ∇4φ = k4φ with ω = k2 √(D/ρh). For a square plate of side a and shapes built from cos(mπx/a) cos(nπy/a) one gets fmn = (π/2a2) √(D/ρh) (m2 + n2).

Mode shapes and mixing

The two degenerate products combine as φmn± = cos(mπx)cos(nπy) ± cos(nπx)cos(mπy). When you drive at frequency f, each mode responds with the resonance amplitude |H| = 1/√((1-r2)2 + (r/Q)2), r = f/fmn, and the simulator sums the shapes that respond by more than 4 % of the strongest one. A low Q makes neighbouring modes mix.

Sand model

Each grain hops in a random direction when the local drive A|u| exceeds a static friction threshold; the hop length grows with the overdrive. Grains therefore random-walk until they sit where A|u| is below the threshold: on the nodal lines. This reproduces the qualitative figure, not the detailed physics of grain bouncing.

Honest simplifications

The shapes are the classic cosine idealisation (exact for a simply supported plate in the sense of the frequency law, approximate for a free square plate whose true modes need a Ritz solution), so real plates differ in frequency by roughly 10 to 30 %. The splitting slider only mimics the way real plates lift the degeneracy of the ± modes. The plate is driven at its centre in all cases; air damping, sand mass loading and bouncing are ignored. Educational model, not a plate-design tool.

Model checks in this page

(1) finite differences of mode (2,3)- satisfy ∇4φ = k4φ; (2) the mean |u| over uniformly scattered grains equals (2/π)2 for a product mode; (3) the number of sign changes along a line equals m.

Resonance spectrum of the plate
Mode frequencies f_mn vs m^2 + n^2
Sand collecting on the nodes (time)
Displacement along a strip with sand density