🚵 Mountain Biking: Downhill Speed, Drag and Suspension Lab

2D interactive simulation · educational model
The science

Along the trail. A rider of total mass m on a slope of angle θ accelerates as m dv/dt = m g sinθ − Crr m g cosθ − ½ ρ CdA v² + P/v − Fbrake. Air density ρ = 1.2 kg/m³. CdA is drag coefficient times frontal area (upright 0.6-0.8 m², tucked 0.35-0.45 m²; typical values). With no pedalling and no brake the speed approaches the terminal value vt = √(2 m g (sinθ − Crrcosθ) / (ρ CdA)) and follows v(t) = vt tanh(t √(a k)) where a = g(sinθ − Crrcosθ) and k = ρCdA/2m. This is the first check below.

Suspension. One wheel is modelled as the classic quarter-car: sprung mass ms = 0.45 m on a spring ks and damper cs = 2ζ√(ksms), an unsprung wheel mass mu = 3 kg, and a tyre spring kt ≈ 45 kN/m × pressure[bar] (a rough linear fit, not a tyre test). The tyre can push but not pull, so a big bump can lift the wheel (flagged AIRBORNE). The first resonance of the undamped system is the lower root of msmuω&sup4; − [ms(ks+kt) + muks]ω² + kskt = 0, typically 1.5-3 Hz for a fork — the simulator is checked against it. Static sag is msg/ks.

Honest simplifications. The bike is a point mass along the slope; the rear-wheel quarter-car is driven by the trail roughness under it, the front wheel and pitch dynamics are not simulated. Roots and rocks are a sum of sine waves plus Gaussian humps (illustrative, not a measured trail). Bumps in the picture are drawn 3× larger so they are visible. Braking is a constant deceleration (no tyre-grip limit, no skidding). Pedal force is capped at 250 N and speed below 1.5 m/s is treated as 1.5 m/s in P/v. Speeds above ~50 km/h on a real trail also need corner and braking skill the model does not include — this is a physics demo, not riding advice.