3D Pulley System

Block and tackle with 1 to 6 supporting strands: force, rope travel, sheave friction and energy.

Switch to 2D

Presets

Playback

Rig

Pull

Camera

Layers

Quality

Model check

The science

What is modelled

A block and tackle in a workshop. A rope runs between an upper block fixed to a beam and a lower block that carries a stack of cast-iron plates. You choose how many rope strands support the lower block (1 to 6), the load, the pull force and the friction of the sheaves. The hand end moves N times as far as the load rises, so the force can be N times smaller, but the work is the same.

Equations

  • Ideal mechanical advantage: MA = W / F = N, where N is the number of rope strands that pull on the lower block and W = (m + mblock) g.
  • Rope length is fixed: the hand end moves shand = N · h when the load rises by h, so the speed at the hand is N v.
  • Sheave friction: each of the N sheaves that the rope passes (N − 1 turns in the blocks plus the guide sheave) changes the tension by a factor η. Lifting: strand j from the hand has tension F ηj, so the total pull on the load is F S with S = Σ ηj, j = 1..N. Lowering the factors are 1/η instead.
  • Motion: meff a = F S − W with meff = m + mblock + N msheave + N² mtail (the rope tail and grip, moving N times faster, count N² times).
  • Energy: F N h = W h + ½ meff v² + Q, with the friction heat Q = ∫ F (N − S) dh. Efficiency at constant speed: ηtackle = W / (N F) = S / N.

Checks run in the page

  • With ideal sheaves the force that holds the load times N equals the weight for N = 1 to 6, and the load stays put for 4 s of integration.
  • The total length of the drawn rope (straight pieces, arcs on the sheaves, the hanging haul end) is the same at three different lifts, so the hand end really moves N times as far.
  • A test lift: hand work equals potential energy plus kinetic energy plus friction heat.

Honest simplifications

  • Friction is a constant efficiency per sheave (no rope stiffness, no speed dependence, no bearing torque that depends on the load). The rope is massless and inextensible except for the lumped tail mass; sheave inertia is a lump of 0.25 kg each. The lower block is 2 kg. The sheaves are drawn in one plane for clarity; real tackle puts the sheaves side by side on one axle so the strands stay parallel. The stop at the top (haul travel limited to 2 m) is an inelastic buffer. Rope tension colours are scaled to the load weight.

What to try

  • Press "Set force to lift" for N = 1 and for N = 6 and compare the force with the hand speed.
  • Set the efficiency to 0.7: the tackle with six strands now wastes much more than the one with two.
  • Use "Set force to hold" and then lower the force a little: friction keeps the load still for a while.
  • Watch the tension colours of the strands: the end near the hand carries the least when lifting.
Loading model...
Loading Blender model...
Force to lift vs number of strands
Load rise and rope hauled
Energy bookkeeping
Made with 🟠 Blender · Three.js