Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
A sport hot-air balloon with an envelope of 2800 m³ (about 18 m wide), a basket with two burners and propane tanks, a parachute vent at the crown and a pilot who flies it. The envelope is open at the bottom, so the air inside is at the same pressure as the air outside; heating it makes it expand and spill out of the mouth, which lowers its density. The balloon floats when the weight of the displaced cold air exceeds the total weight (fabric, basket, fuel, people and the remaining hot air).
Equations
- Gas law:
ρ = p/(R T), so hot air at 100 °C weighs 0.95 kg/m³ against 1.225 kg/m³ for 15 °C air. The mass of hot air inside ismi = p V/(R Ti). - Net force:
F = (ρa − ρi) V g − M g. The floating temperature isTn = Ta / (1 − M/(ρaV)). - Vertical motion with drag and added mass:
(M + mi + ½ρaV) dv/dt = F − ½ ρa Cd A v|v|, so a steady climb rate is√(2F/(ρa Cd A)). - Heat balance of the hot air at constant pressure:
mi cp dTi/dt = η Q − h As (Ti − Ta) − (qv/V) mi cp (Ti − Ta), with burner power Q (fuel energy 46 MJ/kg, η = 0.9), fabric loss coefficient h over As = 1000 m², and the vent flowqv = Cv Av √(2 g H (ρa − ρi)/ρi)replaced by outside air at the mouth. - Atmosphere (ISA):
T = T0 − 0.0065 z,p = p0(T/T0)5.2559. Wind: speedw10(z/10)0.22with a direction that turns (veers) with height; the balloon drags toward the local wind, so it can steer only by changing height.
Checks run in the page
- Air density against the published 1976 US Standard Atmosphere at five heights.
- Steady climb rate against
√(2F/(ρ Cd A)). - Heating without losses against the closed form
T1 exp(η Q t R/(p V cp)). - Ten-minute cooling against the closed form of
dT/dt = −k T (T − Ta). - A steady hover: with exactly the burner power
h A (Tn − Ta)/ηthe temperature and height stay put.
Honest simplifications
- The hot air is one lump with a single temperature; real envelopes are warmest at the crown, which gives extra lift for the same mean temperature, and there is a pressure difference inside that is ignored.
- Fabric loss is a single effective coefficient (conduction, convection and radiation together); real values depend on the wind, the fabric and the sun. The same goes for Cd = 0.45 and the added-mass factor.
- The burner is a heat source with fixed efficiency; the vent mixes outside air instantly. Envelope shape is fixed except for a purely visual sag when the air is cold. Balloon, basket and fabric masses are typical round numbers, not a particular aircraft.
- Wind is a smooth made-up profile that depends only on height, with no turbulence, thermals or terrain. The flight happens over a flat, endless, repeating field.
- This is an educational model: real flights need training, weather briefings and air-traffic rules.
What to try
- Hold the burner and watch the air temperature climb past the "needed to float" line; the balloon lifts off a little after it crosses.
- Press Autopilot at 600 m: the burner pulses and the vent trims the climb rate.
- Raise the load to 450 kg or lower the ground temperature and see how much hotter the air must be.
- Fly at different heights to find the wind layers; veering lets you steer by going up or down.
Loading model...
Loading Blender model...