3D Gecko Adhesion

A gecko on glass: setae, spatulae and the 1/D^3 van der Waals law, from the whole animal down to one seta.

Switch to 2D

Presets

Playback

Contact physics

Animal and surface

Camera

Layers

Quality

Model check

The science

Why a gecko sticks

There is no glue and no suction. The toes carry about 14,000 keratin hairs (setae) per square millimetre; each seta ends in a few hundred flattened tips (spatulae). When a spatula lies flat within a fraction of a nanometre of the surface, the fluctuating dipoles of the two materials attract each other: the van der Waals force.

Equations used

  • Pressure between two flat surfaces at gap D: P = A / (6 π D3) with Hamaker constant A (about 10-19 J for keratin on glass in air). It follows from summing the pair potential -C / r6 over both bodies (A = π2 ρ2 C).
  • Force on one spatula: Fsp = P · a, with a the contact area of the tip; force on one seta: Fseta = nsp Fsp. For a spherical tip of radius R the Derjaguin result is F = A R / (6 D2).
  • A seta only makes flat spatula contact when it is dragged to a low angle with the surface. The page uses a critical angle αc = 30° (Autumn 2000) with Gaussian scatter σ: engaged fraction η = Φ((αc - αmean) / σ). Pressing the pad down lowers the mean angle, lifting and peeling the toe raises it, which is how the animal detaches without effort.
  • Foot capacity: pull-off FN = η ρ Apad Fseta, shear limit FT = 4.85 FN (measured 194 uN shear vs 40 uN normal per seta).
  • Load on a surface tilted by φ from horizontal, shared by n feet: T = m g sinφ / n (along the surface), N = m g cosφ / n (negative = pull-off). Safety factor from the interaction ellipse SF = 1 / √((T/FT)2 + (Npull/FN)2).

Checks run in the page

  • Pairwise 1/r6 summed numerically over two half-spaces reproduces A/(6πD3).
  • Ring summation of the plate-plate pressure under a spherical tip reproduces the Derjaguin formula.
  • The reference seta (A = 10-19 J, D = 0.34 nm, 400 spatulae) is compared with the measured ~40 uN per seta.

Honest simplifications

  • The contact area per spatula, the gap D and the Hamaker constant are effective values chosen so one seta lands near the measured force; real tips are rough and partly wet, and humidity and capillary forces add to van der Waals attraction. Pad area per foot, setae density and the 30 degree rule are order-of-magnitude literature values.
  • All the setae of a foot share one mean angle; real toes engage progressively as they roll on. The load is shared equally by the feet in contact, whereas a real animal redistributes forces actively (on a ceiling front and hind feet pull against each other). The micro stage is not to scale: it shows tens of setae, and the gap D is exaggerated about 2 scene units per nanometre.
  • The maximum is a theoretical ceiling with every seta engaged; real geckos use only a few percent of it, which is why they can release their feet in milliseconds.

What to try

  • Lower the pad preload to zero: the setae stand steep, the engaged fraction collapses and the animal peels off. Switch on the walking step cycle to watch attach, hold, peel and swing.
  • Raise the contact gap D from 0.34 to 1.2 nm (dirty or rough glass): pressure drops by a factor 40 because of the 1/D3 law.
  • Rotate the surface to 180 degrees and use one foot only.
Loading model...
Loading Blender model...
Van der Waals pressure vs gap
Engaged setae vs seta angle
Safety factor vs surface angle
Step cycle: engagement and preload
Made with 🟠 Blender · Three.js