3D Clockwork Gears: Gear Train, Escapement and Pendulum Rate

A skeleton pendulum clock: follow the 450:1 gear train from mainspring weight to escape wheel, regulate the pendulum and read the rate in seconds per day.

Switch to 2D

Presets

Playback

Pendulum, weight and environment

Actions

Camera

Layers

Quality

Model check

The science

Gear trains. Two meshing gears must have the same tooth size (module), so the teeth passing the contact point per second are equal: NAωA = -NBωB (the minus sign is the reversal of the direction). The speed ratio is therefore a ratio of tooth counts, and with a lossless mesh the torque ratio is the inverse: τB = (NB/NA) τA η, so power τω is conserved apart from the mesh loss (here η = 0.93 per mesh). This movement has barrel 90 / pinion 12, centre wheel 80 / pinion 10, third wheel 75 / pinion 10 and a 30-tooth escape wheel: 7.5 × 8 × 7.5 = 450. The escape wheel turns once a minute, the centre arbor once an hour (1/60), and the 12:1 motion work (10/40 × 10/30) turns the hour hand once in twelve hours.

Pendulum. A real pendulum is a rigid body: ω02 = M g d / I with I the moment of inertia of rod and bob about the pivot. For large swings the period grows: T = T0/AGM(1, cos(θ0/2)) ≈ T0(1 + θ02/16), the “circular error” that makes a clock with a bigger swing run slower. The rod length changes with temperature, L = L20(1 + α(T - 20)), so a steel rod makes a clock lose about 0.5 α × 86400 ≈ 0.5 s per day for each degree of warming; Invar nearly removes the effect.

Escapement. The escape wheel is held back by the anchor and released once per beat (every zero crossing of the pendulum, 1 s for a 2 s pendulum), advancing half a tooth pitch (π/30). The work given to the pendulum per beat is W = ηimp τesc π/30, delivered here as a kick of kinetic energy at the bottom of the swing. Friction and air drag remove πE/Q per beat, so the swing settles where W = πE/Q, giving θ02 = 2 W Q /(π I ω02). If the steady swing is below the lock-up angle (0.6 deg) the anchor cannot release the wheel and the clock stops.

Honest simplifications. The tooth profile is a simple trapezoid, not a true involute, and the gears are rigid and frictionless apart from a constant efficiency per mesh. The impulse efficiency (0.6), the Q factor, the 20 mm drum and the 0.6 deg lock-up are plausible round numbers, not measurements of a particular clock. The escapement is reduced to an energy kick at the bottom of the swing: recoil, drop and the dependence of the impulse on the swing angle are ignored, as are the pendulum’s suspension spring and air buoyancy. The visual swing can be exaggerated for readability (the physics always uses the true angle), and the animated tick of the escape wheel is smoothed. The rate figure in seconds per day assumes the train is designed for a 1 s beat.

Loading model...
Loading Blender model...
Pendulum angle over the last 12 seconds
Circular error: rate against swing amplitude
Clock error accumulating over time
Steady swing against driving weight
Made with 🟠 Blender · Three.js