loading...
running...
The science
Energy conservation. A coaster car has no engine after the chain lift lets go. Its mechanical energy per unit mass is e = g y + v2/2, with y the height above the loop base. Without friction e is constant, so the speed depends only on height:
v(y) = √( v02 + 2 g (y0 - y) ) (independent of the shape of the track and of the mass)
The page keeps a full ledger: kinetic + potential + heat from rolling friction, air drag and the brake run always add up to the energy the chain lift supplied. The residual is shown live and is checked below.
Motion along the track. The track is built from straight lines and circular arcs, parametrised by arc length s. The tangent makes an angle θ(s) with the horizontal, the signed curvature is κ(s) = dθ/ds. The car obeys
dv/dt = - g sinθ - sgn(v) μ g max(0, Gn) - sgn(v) (ρ CdA / 2m) v2, ds/dt = v
integrated with a fixed-step fourth-order Runge-Kutta method.
Rider g-force. The normal acceleration of the car is v2κ towards the centre of curvature. The seat must also carry the component of gravity along the normal, so the load in units of g is
Gn = v2 κ / g + cosθ
At the bottom of a valley κ > 0 and cosθ = 1 so you feel heavy; over a crest κ < 0 and Gn falls towards zero (airtime). For a frictionless circular loop of radius R entered from an energy height heff = e/g above the base:
Gbottom = 2 heff/R + 1, Gtop = 2 heff/R - 5, loop clears when heff ≥ 2.5 R
At exactly 2.5 R the rider is weightless at the top (v2 = gR). Below that the car on a real coaster stays on the rail because its wheels hold it, but the rider would leave the seat: the simulation flags it and shows negative G.
Why a real loop is not a circle. Real loops are clothoid-like (tight at the top, gentle at the entry) to keep the peak g-force bearable. A circle is used here so that the closed-form check is exact; jumps in curvature at the joins therefore show up as sharp steps in the g-force graph.
Checks (run in the page). (1) the energy ledger drift over the whole frictionless ride; (2) the g-force at the loop top and (3) at the loop entry against the formulas above; (4) the time to roll down the straight first drop against t = (−v0 + √(v02 + 2aL))/a with a = g sinα.
Simplifications. A point mass on the rail (no rotation of the wheels, no car length, no sway, no lateral forces); rolling friction proportional to the normal load; quadratic air drag with a constant CdA; the brake run is a constant plus linear deceleration; the loop is shifted sideways in 3D only so the two sides of the loop do not collide.