Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
A mirror ball of radius 0.40 m is covered with about 1,950 flat square mirrors, 28 mm on a side, laid out in latitude rows with a 32 mm pitch (the gaps are grout). Up to three point-like spotlights shine on it from the walls near the ceiling. Every tile that faces a lamp is traced separately: the incoming ray, the reflected ray, the point where it hits the floor, a wall or the ceiling, and the size and brightness of the light spot it leaves there. The ball turns about its vertical axis at the chosen rate.
Equations
- Law of reflection for a unit incident direction
dand tile normaln:r = d − 2 (d·n) n, so the angle of incidence equals the angle of reflection and the three vectors are coplanar. - A flat mirror is the same as a lamp image behind the mirror: the reflected beam spreads as if it came from the mirror image of the lamp. A tile of edge
a, a lamp paths1and a wall paths2therefore gives a spot of edgew = a (s1 + s2) / s1, stretched by1/cos(θw)along the direction in which the beam meets the surface obliquely. - Brightness: power through the tile
Φ = ρ I a² cos i / s1²over a spot areaw²/cos θwgivesE = ρ I cos i cos θw / (s1 + s2)²: an inverse-square law in the total path length. - Turning rule: if a mirror turns by
δand the incident beam stays put, the reflected beam turns by2δ. A spot at distances2from the ball on a surface hit at an angleθwtherefore travels atv = 2 ω s2 / cos θw(the formula that gives the fastest-spot readout). - Tile count: sphere area divided by the pitch squared,
4 π R² / p², matches the number of tiles in the latitude-row layout.
Checks run in the page
- Vector reflection against the mirror-image construction for every lit tile (the spot positions must coincide).
- A fixed beam on a flat mirror turned by 1 degree: the reflected beam turns by exactly 2 degrees.
- Number of tiles against 4 π R² / p².
- A very distant lamp: the projected area of the lit tiles against π R² (a/p)², the ball's shadow times the fill factor.
- Spot size from tracing the four corner rays of one tile against the similar-triangles formula.
Honest simplifications
- Geometrical optics only: the lamps are point sources, diffraction at the 28 mm tiles and the spread of a real lamp's beam are ignored, so edges of the spots are perfectly sharp and the real spots would be softer and larger.
- The room is an empty box with perfectly diffuse surfaces; light is traced once (lamp - tile - surface). Light that bounces on from the walls, the second reflection from tile to tile and shadows of the motor, chain and axle are not traced.
- The brightness colours are relative and only compare spots with each other; the glow of the lamps themselves and the haze lines are cosmetic. The haze slider changes how bright the beams are drawn, not any physical scattering law.
- The mirror is treated as a single constant reflectivity for all angles; a real aluminium or glass mirror loses more light at grazing incidence.
- Tiles are flat and perfectly aligned to the sphere; a real ball has slightly uneven tiles, which scatter some spots.
What to try
- Freeze the ball (preset) and count the squares on a wall, then spin it and read the fastest spot speed.
- Double the rotation rate: the beams turn twice as fast, as the rule 2 omega says.
- Turn on the third lamp and watch the number of spots grow by about the same count again.
- Look at the spots near the corners of the room: they stretch and race, because the beam meets the surface at a grazing angle.
Loading model...
Loading Blender model...