3D Maple Seed Autorotation: Samara Blade-Element Model

Why a maple key spins: blade-element lift and drag set the descent speed, spin rate and coning angle; compare with a locked wing.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

A maple key (samara) is a single seed with one wing. Released, it flips into autorotation: the wing spins about the seed like a helicopter rotor in a power-off descent, the spinning wing carries lift, and the seed falls at roughly a quarter to half the speed of a plain falling leaf-sized plate. Here the wing is split into 28 blade elements; at every time step the air flow at each element (descent speed plus rotation speed) sets its angle of attack, lift and drag, and the total force and torque drive the fall speed V and the spin rate Ω.

Equations

  • Flow at a blade element at radius r: tangential speed Ω r, vertical speed V, so φ = atan(V / Ω r), U² = (Ω r)² + V², angle of attack α = θ(r) + φ (θ = blade pitch).
  • Flat-plate coefficients: CL = 1.8 sin 2α, CD = 0.07 + 1.9 sin²α. Element forces dL = ½ ρ U² c CL dr, dD = ½ ρ U² c CD dr.
  • Vertical force dFz = dL cosφ + dD sinφ, force along the rotation dFt = dL sinφ − dD cosφ. Equations of motion: m dV/dt = m g − Fz − Fseed, I dΩ/dt = ∫ dFt r.
  • Autorotation steady state: torque zero, so the lift tilted forward by φ exactly balances the profile drag; the weight is carried by Fz. The wing cones upward until the centrifugal moment balances the lift moment: sin 2β = 2 M / (Ω² Iflap).
  • Power: the lift does no net work, so m g V = ∑ dD U plus the seed body drag; this is one of the in-page checks.

Checks run in the page

  • Power balance: weight power against the sum of dD U over the elements.
  • Discretisation: 40 against 640 blade elements give the same lift and torque.
  • Locked wing: the time-stepped fall reaches the speed given by an independent bisection of m g = drag(V).

Honest simplifications

Real samaras have a leading-edge vortex that raises the lift beyond a flat-plate fit, the pitch distribution is set by the seed and the wing shape together, and the descent is rarely perfectly axial. This model has no induced-inflow correction, uses fixed flat-plate coefficients, assumes a uniform chord-weighted mass distribution, and no tip loss, so the computed descent speed (about 0.6 m/s here) is lower than the 0.9 to 1.2 m/s measured for real Norway-maple fruit; the trends (heavier seed falls faster, longer wing falls slower, stalling blade does not autorotate) are the point. Wind only moves the drift estimate; it is not drawn as a force. The seed is drawn magnified; the dimensions in the readouts are real.

What to try

  • Choose the No initial spin preset: the wing may fall without ever autorotating, the speed jumps to the locked-wing value.
  • Raise the blade pitch in the graph on the right and see where autorotation fails (red dots).
  • Use a long slender wing against a short broad one: the span sets the disc loading.
  • Watch the Seed from above camera: the cyan disc is the rotor disc, its radius shrinks as the wing cones up.
Loading model...
Loading Blender model...
Descent speed vs time
Spin rate and coning angle vs time
Terminal speed vs blade pitch
Made with 🟠 Blender · Three.js