Presets
Playback
Apparatus
Lighting
Model checks
The science
What is modelled
The canopy is a stack of leaf layers. Light of the given photosynthetic photon flux (PAR) is absorbed layer by layer, each layer fixes CO2 according to a saturating light-response curve whose maximum depends on temperature and CO2, and the layers are summed. Air temperature and humidity set the vapour pressure deficit, which closes the stomata and drives transpiration. The 3D greenhouse's own simple climate-quality and yield rule is shown next to it for comparison.
Equations
- Beer-Lambert light
I(L) = I0 e-k Lwith extinction coefficient k = 0.7 and leaf area index L. - Leaf response (rectangular hyperbola)
A = α I Amax / (α I + Amax), α = 0.05, with Amax peaking near 26 C and rising with CO2 asC / (C + 300). - Canopy total
(Amax / k) ln[(α I0 + Amax) / (α I0 e-k LAI + Amax)]minus canopy respiration. - Saturation vapour pressure (Tetens)
es = 0.6108 exp(17.27 T / (T + 237.3))kPa,VPD = es (1 - RH). - Stomatal conductance
gs = 0.35 / (1 + VPD / 1.5), transpirationE = gs VPD / P · LAI.
Checks run in the page
- Layer-by-layer sum against the closed-form canopy integral.
- A 200,000-photon free-path test of the absorbed fraction 1 - e-kL.
- Tetens against the tabulated vapour pressure and the Clausius-Clapeyron slope.
- The low-light slope and high-light plateau of the response curve.
Honest simplifications
One crop type, one extinction coefficient, no leaf angle distribution, no diffuse and direct light split, no heat balance of the leaves and a made-up temperature curve. Transpiration is a conductance times a deficit, not a full Penman-Monteith model. The 3D yield rule is only a toy that rewards temperature near 24 C and humidity near 70 percent.
What to try
- Choose Dense canopy: the lower leaves go dark and the profile shows the extra leaf area adds little.
- Choose Hot dry day: the vapour pressure deficit climbs and stomata close, so water use efficiency changes.
- Raise CO2 to 1000 ppm and see photosynthesis rise at the same light.