UV nanoimprint lithography (UV-NIL) presses a transparent mold patterned with nanoscale trenches into a thin liquid resist. Capillary forces, not the applied pressure, do the actual filling: resist wicks up each trench the way ink climbs a fine tube.
Washburn equation (capillary rise):
L(t) = √( r·γ·cosθ / (2η) · t )
Capillary number (viscous vs. capillary forces):
Ca = η·v / γ
r is the trench half-width, γ the resist surface tension, θ the contact angle, η the viscosity, and v the mold's descent speed. Low Ca means capillary forces dominate: the meniscus in every trench has time to advance smoothly and air is pushed out ahead of it as the mold seats. High Ca means the mold seats faster than the meniscus can climb, so pockets of air get sealed in mid-trench and freeze there as bubble defects once the resist is UV-cured.
- Mold descent speed v — faster descent raises Ca and starves each trench of the time it needs to fill without trapping air.
- Resist viscosity η — a thicker resist raises Ca and slows the Washburn front, so runs are shown at a proportionally slower rate.
- Surface tension γ — a higher-γ resist lowers Ca and pulls the meniscus in faster, favoring complete, bubble-free filling.
- Each of the 49 trenches also carries a small random sidewall-roughness factor, so even at a fixed Ca some cavities fill cleanly while others near the defect threshold trap a bubble — matching the statistical defect maps seen on real imprinted wafers.
Real-world relevance: keeping Ca low (slow, controlled imprint speed and low-viscosity, UV-curable resists) is exactly why production UV-NIL tools imprint far more slowly than a naive "just press harder" approach — it is the single biggest lever for defect-free sub-10 nm replication.