Roll-to-Roll Nanofilm Coating Line

Landau-Levich film, drying and the line-speed limit.

Switch to 3D

Presets

Playback

Web

How fast the flexible substrate is pulled out of the ink.

Ink

Viscosity sets the wet film, solids set the dry film.

Oven

Heated length and temperature drive the evaporation.

Animation

Only speeds up the picture, not the physics.

Layers

Model checks

The science

Entraining a film

When a flat web is pulled out of a bath at speed v, it drags up a liquid film. For small capillary number Ca = eta v / gamma (below about 0.01) the thickness on each side follows the Landau-Levich law h = 0.9457 l_c Ca^(2/3) where l_c = sqrt(gamma / (rho g)) is the capillary length and eta the viscosity. The constant comes from the thin-film equation f''' = (f - 1)/f^3, whose solution has curvature 0.6430 near the bath; the page solves it numerically as a check. Doubling the speed multiplies the film by 2^(2/3) = 1.59; viscous inks make thicker films.

From wet film to nanofilm

The ink is mostly solvent. If the nanoparticles occupy a volume fraction phi, the dry film is h_dry = phi h_wet. For a 1 % ink a 35 um wet film leaves about 350 nm; the page also counts how many 20 nm particle layers that is, and the solid mass per square metre.

Drying

Solvent leaves at a roughly constant evaporation velocity E(T) = E_0 exp((E_a / R)(1/T_0 - 1/T)) (liquid thickness lost per second) until only the particle film is left. The web first travels 6 m in room air (slow) and then through the heated oven. The film leaves dry if E_air t_air + E(T) L / v >= h_wet - h_dry. Because h_wet ~ v^(2/3) the highest dry-able speed has a closed form: v_max = ((E L + E_air D) / (c (1 - phi)))^(3/5) with h_wet = c v^(2/3). A wet film touching a roller would smear, so the line must stay below it.

Simplifications

One-sided Landau-Levich entrainment from a quiescent bath, a Newtonian ink, no wetting-line or meniscus-pinning effects, no Marangoni flow, a constant-rate evaporation period only (no falling-rate stage, no skin formation), the solvent properties of a typical alcohol ink, a perfectly uniform web and no film cracking. Absolute thicknesses are order-of-magnitude, the scalings are the point.

What to try
  1. Read the default line: a wet film of tens of micrometres becomes a dry film of a few hundred nanometres.
  2. Double the speed and see the thickness grow by about 59 %, not 100 %.
  3. Press the thick viscous ink preset and compare with the dilute ink preset for the final nanofilm thickness.
  4. Press the cold oven preset: the web reaches the rewind roll still wet, shown in blue and below 100 % dryness.
  5. Raise the oven temperature and watch the highest dry-able speed in the last graph climb.
Film thickness along the line, with the oven shaded
Wet and dry film thickness against web speed
Dryness at the oven exit against web speed
Highest dry-able web speed against oven temperature