Presets
Playback
Tool
Tip sharpness and blade shape.
Tissue
Stiffness, strength and toughness (fat, muscle and fascia presets).
Motion and safety
Speed, stroke and the force-feedback limit.
Actions
Layers
Model checks
The science
What this models
This is a physics lesson about pressing a sharp tool into a soft, elastic material. It is not a surgical guide, does not model any procedure, and nothing here is clinical or medical advice. Real tissue is layered, wet, viscoelastic and different in every person; the numbers are illustrative orders of magnitude.
Stage 1: indentation (Hertz contact)
A rigid tip of radius R pushed a depth z into an elastic half-space needs force F = (4/3) E* sqrt(R) z^1.5, with the contact modulus E* = E / (1 - nu^2) (nu = 0.5 for nearly incompressible tissue). The peak contact pressure is p0 = (2E*/pi) sqrt(z/R). The work stored in the tissue is (8/15) E* sqrt(R) z^2.5.
Puncture
When p0 reaches the local strength sigma the tissue gives way at the depth d_p = R (pi sigma / 2E*)^2 and the force F_p = (4/3) E* sqrt(R) d_p^1.5, which grows as R squared: halving the tip radius needs four times less force. That is why a dull tool needs a hard push while a sharp one barely touches the tissue.
Stage 2: cutting with a wedge
Once through the surface, a V-shaped blade of half-angle theta opens new crack area A = tan(theta) d^2 (two edges). Energy balance F dz = T dA, with toughness T in J/m2, gives F = 2 T tan(theta) d, which stops growing once the whole blade width is engaged. A narrower blade cuts with less force; a wide one needs more.
Force-feedback limit
Surgical robots measure the force at the instrument and can stop or retract when it exceeds a chosen limit. Here the tool retracts automatically when the force crosses your limit.
Simplifications
Hertz theory assumes small strains and a smooth sphere; the puncture depth is several tip radii, so the formulas are used beyond their strict range and give trends, not predictions. The incision is a symmetric V, there is no friction, viscoelasticity, tissue layers with different stiffness, blade vibration or tissue sliding, and the surface dimple is drawn qualitatively. The mid-plane cut view shows half of a symmetric problem.
What to try
- Run the default stroke and watch the force trace: it climbs slowly while the tissue dents, then the puncture happens at a small force and the cutting force rises with depth.
- Change the tip radius from 60 to 600 micrometres: the puncture depth and force jump up. The graph of puncture force against tip radius is a straight line of slope 2 on log axes.
- Choose "Blunt probe": the tissue just dents and never cuts, and the force-feedback limit stops the tool.
- Compare a wide blade with a narrow one in the same tissue.
- Switch to manual mode and drag the tool by hand to feel where puncture happens.