Two immiscible waste polymers (matrix A, dispersed phase B) shear-mixed in an extruder settle into a droplet morphology whose size is set by a balance between viscous shear stress, which stretches and breaks droplets, and interfacial tension, which pulls them back into spheres. A compatibilizer — a block or graft copolymer with one segment miscible in each phase — migrates to the A/B interface and lowers the interfacial tension:
σ(φc) = σ₀ · exp(−k·φc)
with σ₀ ≈ 8 mN/m for an uncompatibilized polyolefin/polystyrene-type pair and k a coverage-saturation constant. The resulting steady-state droplet diameter under simple shear follows Wu's (1987) empirical correlation, calibrated against hundreds of polymer-blend extrusion runs:
d = (4σ / (η_m·γ̇)) · p^n, p = η_d/η_m
n = +0.84 if p ≥ 1, n = −0.84 if p < 1
η_m (matrix viscosity) is held fixed at 200 Pa·s, a representative polymer-melt value. Substituting d back into the capillary number Ca = η_m·γ̇·(d/2)/σ collapses the shear rate and tension terms exactly, leaving Ca = 2·p^n — the equilibrium capillary number depends only on the viscosity ratio, not on how hard you shear or how compatibilized the blend is. That is the real, and often counter-intuitive, content of Wu's correlation: shear and compatibilizer loading only set the length scale (μm droplet size) at which the interface sits at its critical breakup capillary number; the viscosity ratio alone sets how close to that critical point the system equilibrates.
- Compatibilizer loading — raises interfacial coverage, exponentially collapsing σ and shrinking the droplets.
- Shear rate — more intense mixing shrinks droplets at fixed σ and viscosity ratio.
- Dispersed-phase fraction — how much of the melt volume is the minority polymer (denser droplet field, size unaffected by this term in Wu's model).
- Viscosity ratio — droplets are hardest to break near p ≈ 1 (matched viscosities transmit shear stress most efficiently into the droplet); very low or very high ratios need a disproportionately high Ca to break up, which is why real recycling streams pick catalysts and additives partly to nudge p toward that window.
Real-world relevance: this is exactly why sorting-imperfect mixed plastic waste (PE/PP/PS/PET jumbled together) cannot simply be melted and reprocessed — without a compatibilizer the phases stay coarse and weakly bonded, embrittling the recycled part. Reactive and block-copolymer compatibilizers are the main lever the polymer-upcycling industry uses to turn a mixed waste stream into a usable material instead of scrapping it.