Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
Crude bismuth is purified by zone refining: a short molten zone is swept along a solid bar inside a quartz tube. When a liquid freezes, an impurity usually does not enter the new crystal in the same proportion as it was in the melt; the ratio is the distribution coefficient k. For k < 1 the solid that freezes behind the zone is cleaner than the liquid, so the impurity is carried along with the zone to the far end of the bar. Repeating the pass sharpens the effect. The page moves the zone cell by cell along a bar of 400 cells and tracks the impurity in the solid and in the stirred molten zone, with a Blender-made furnace rig around it.
Equations
- Zone of n = l/dx cells with a uniform liquid concentration CL. Advancing by one cell: the freezing cell takes
Cs = k CL, the melting cell adds its solid concentration, son CL′ = n CL − k CL + Cs(melting cell). Impurity is conserved exactly. - One pass from a uniform bar:
Cs(x) = C0 [1 − (1 − k) exp(−k x / l)](Pfann). When the zone reaches the end it freezes by normal freezing,Cs = k C0 (1 − g)k−1(Scheil), which piles the impurity into the last zone length. - After many passes the profile approaches the ultimate distribution
Cs ∝ exp(B x)withk = B l / (exp(B l) − 1); a short zone and many passes give the cleanest start of the bar, but each extra pass costs a full travel timeL / v. - Heat to advance the zone:
P = ρ A v (Lf + cp (Tm − T0))with bismuthρ = 9.78 g/cm3,Lf = 53.1 kJ/kg,cp = 0.122 kJ/(kg K),Tm = 271.4 C.
Simplifications
- The distribution coefficient is a free slider, not a measured value for a particular impurity: the real k of lead, antimony, arsenic or tin in bismuth depends on temperature and composition, and some elements (such as those that form compounds with bismuth) behave quite differently. The page demonstrates the mechanism, not a purity prediction for a real melt.
- The liquid zone is assumed perfectly mixed with a sharp, fixed length and a constant k; real zones have a diffusion boundary layer (an effective k closer to 1 at fast travel speeds), changing shape, convection and evaporation. Bismuth also expands by about 3 % on freezing, which is ignored.
- The heat figure is only the enthalpy needed to melt the advancing bar; losses of the furnace are not modelled. The industrial route for crude bismuth also uses chemical (oxidative and alkaline) refining steps before any zone melting; this page shows only the physical segregation step.
- The impurity piled up at the far end can reach tens of percent in the model; a real melt would saturate there and form a second phase (a compound or eutectic), which is not modelled.
- Impurity levels are shown in ppm of the starting level; at very low levels real purity is limited by contamination from the boat and atmosphere, which is not modelled.