Rotary Kiln Reactivation of Spent Activated Carbon: Drying, Desorption, Char and Steam Burn-Off

Wet, loaded carbon is dried, stripped of its adsorbate and cleaned of char by steam in a counter-current rotary kiln; too cold leaves the pores blocked, too hot or too long burns the carbon away.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What you see. A rotary kiln that reactivates spent activated carbon. Wet carbon loaded with adsorbed organics enters at the high (left) end, tumbles down the slightly inclined drum while hot gas from the burner flows the other way, and leaves cleaned. The jacket is cut open at the front; the dark bed glows with the temperature of the solids, blue dots are the flue gas.

What happens along the drum. (1) Drying: the carbon stays at 100 °C while water evaporates (2.26 MJ/kg). (2) Desorption and pyrolysis: the adsorbate decays by a first-order Arrhenius law da/dt = −kd a, kd = A e−E/RT; a fraction φ stays behind as char that blocks the pores. (3) Steam activation: C + H2O → CO + H2 (+131 kJ/mol) removes the char about 40 times faster than the carbon skeleton, so a good programme clears the pores while burning only a few percent of the carbon.

Heat. The bed follows the gas with a lumped time constant (dT/dt = (Tg − T)/τth scaled by the heat capacity of the load). The gas side is the exact counter-current balance Tg(z) = Tburner − Qabs(z..L)/Cg, solved by iteration until the gas and solids profiles agree. The throughput follows from the bed volume of the Blender mesh and the residence time.

Honest simplifications. Steady state, plug flow of solids, one lumped bed temperature (no radial gradients), constant heat capacities, one pseudo-adsorbate with one activation energy, a constant steam partial pressure and one gasification rate law with an assumed char-to-carbon reactivity ratio of 40. The rate parameters are tuned to give plausible reactivation (a few percent carbon loss, nearly clean pores at the design point), not measured for a particular carbon. The pore-blocking factor (8 × char mass) and the iodine-number mapping are illustrative relations, not a measured isotherm.

Checks. (1) The integrator reproduces the exact exponential decay of both reactions at a held temperature; (2) the heating law and the drying energy equal their closed forms; (3) mass closes for every kg of carbon and the gas-side balance equals the heat taken up by the solids; (4) the bed volume integrated from the GLB equals the circular-segment formula.

Loading model...
Loading Blender model...
Solids and gas temperature along the kiln
Moisture, adsorbate, char and burn-off along the kiln
Product quality against residence time
Made with 🟠 Blender · Three.js