Birthday Candle (2D cross-section)

Cut-away of a burning candle: capillary wick supply against fuel demand, flame height and zones, the melt pool, oxygen under a jar and the distance at which a breath blows the flame out.

Switch to 3D

Presets

Playback

Actions

Light the wick, blow, cover with a jar or restart the capillary test.

Wick and wax

Wick length and pore radius set how much molten wax can be carried; gravity changes the capillary head.

Breath and jar

Breath speed, distance to the flame, jar volume and the clock.

Layers

Model checks

The science

What happens

A candle is a self-feeding fuel system. The flame melts the wax, the wick soaks the molten wax up by capillary action, the wax evaporates in the hot zone and burns in the flame. The wick must deliver exactly as much wax as the flame demands: too little and the flame starves; too much (a long wick) and it smokes.

Equations

Capillary rise in a pore of radius r follows the Washburn equation with gravity, dh/dt = (r^2 / 8 mu h)(2 gamma cos(theta) / r - rho g h), which ends at the Jurin height h = 2 gamma cos(theta) / (rho g r). The wick supply is a Hagen-Poiseuille flow, m_sup = rho phi A (r^2 / 8 mu)(dP / L) with dP = 2 gamma / r - rho g L. Fuel demand grows with the exposed wick length, about 0.1 (L_w / 6 mm)^0.8 g/min, and the flame height scales with the burn rate.

A breath of speed U0 reaches the flame as a jet that dilutes with distance, u = U0 min(1, 6.2 d / x). The flame is blown out when the air speed stays above the critical value u_c = 2.2 sqrt(m_f / 0.1) long enough that the stripped-vapour dose reaches 1. Under a jar the oxygen fraction falls as the flame consumes it until x_O2 = 16 %.

Honest simplifications

The wick is a bundle of identical straight pores; the flame is described by a few scaling laws (height, power, critical blow-out speed) rather than a combustion simulation; the jet dilution and the 16 percent oxygen limit are textbook-level estimates. The 2D view uses the same physics module as the 3D page. Light the candle only with a grown-up in real life.

Checks in the page

Check 1 compares the Washburn ODE against the Jurin height and the sqrt(t) start law. Check 2 compares the stepped oxygen depletion under a jar with the closed formula. Check 3 compares a bisection search for the blow-out distance with the formula for the maximum distance.

What to try
  • Press Light it, then lengthen the wick: demand rises above what the pores can supply and the flame gets sooty.
  • Press Blow at 30 cm and then at 80 cm with the same breath: the jet dilutes with distance, so the far flame survives.
  • Put the jar on and watch the oxygen curve fall to 16 percent, where combustion stops.
  • Switch the liquid in the capillary test: water rises higher than wax but more slowly than you expect because of viscosity.
Wick supply vs pore radius
Capillary rise in the wick (log time)
Oxygen under the jar
Blow-out distance vs breath speed