3D Geodesic Dome

Icosahedral struts and hubs analysed as a truss: strut classes, snow and wind loads, tension and compression, buckling.

Switch to 2D

Presets

Playback

Dome and struts

Loads

Camera

Layers

Quality

Model check

The science

What a geodesic dome is

A geodesic dome approximates a sphere with many short straight struts forming triangles. Start from an icosahedron, split every edge into v equal parts (the frequency), join the points and push them out onto the sphere. The triangulated shell carries load by pure tension and compression in its struts, so it is light for its size.

Geometry

  • Class-I subdivision of the 20 icosahedron faces gives a full sphere with V = 10v2 + 2 vertices, E = 30v2 edges and F = 20v2 faces. The page cuts it at a height that leaves 3/8, 1/2 or 5/8 of a sphere.
  • Strut lengths come in a few classes (chord factors times the radius R): 1V 1.0515; 2V 0.5465 and 0.6180; 3V 0.3486, 0.4035 and 0.4124.

Structural model

  • Pin-jointed truss: each strut is an axial spring k = EA/L; the global system K u = f is assembled and solved by Cholesky factorisation, with all nodes of the base fixed in space.
  • Load cases: dead (struts, hubs, cladding), snow (s in kPa on the horizontal projection of up-facing panels) and wind (dynamic pressure q = ½ ρair v2 with pressure coefficients +0.8 · cos on the windward side and −0.5 on the rest). Because the model is linear, the three results are combined by superposition.
  • Capacity: tension fy A; compression the smaller of fy A and the Euler load π2 E I / L2. Utilisation is force divided by capacity.

Checks run in the page

  • Euler characteristic: a disc-shaped dome must satisfy V − E + F = 1.
  • Full-sphere counts 10v²+2, 30v², 20v² and the published chord factors for 1V and 2V.
  • Global equilibrium: the sum of all applied loads equals the support reactions computed from the strut forces.

Honest simplifications

  • Real domes have rigid or semi-rigid joints and bending in the struts; a pin-jointed truss ignores both and can be slightly optimistic or pessimistic. Buckling is checked strut by strut (no global or snap-through buckling), with a pinned effective length factor of 1.
  • Snow and wind patterns are crude and not a design code calculation; there are no partial safety factors, no connection design and no foundation analysis. Do not use this to design a real structure.

What to try

  • Compare 2V, 3V and 5V at the same tube size: finer frequency means shorter struts, much higher buckling capacity and a different mass.
  • Raise the snow load until the governing strut turns red, then read the snow capacity.
  • Turn on 40 m/s wind and watch the windward struts go into compression.
Loading model...
Loading Blender model...
Strut length classes
Axial force of every strut (sorted)
Max utilisation vs snow load
Mass vs frequency
Made with 🟠 Blender · Three.js