Setting up the quarry bench…
⛏ Splitting bench controls
2D side-on lab with graphs →
The science

What you see. A slate block with a rigid lower half and a thin sheet (thickness t) that a splitter wants to lift off along the cleavage plane. The wedge is driven in by mallet blows. The crack runs ahead of the wedge until the whole sheet comes free, or the sheet snaps.

Model (Obreimoff wedge test). The lifted sheet is a cantilever clamped at the crack tip, length a, loaded at the mouth where the wedge opens it by h = 2 s tanθ (s = wedge depth): P = 3EI h / a³, I = b t³/12. The crack runs when G = 3 E t³ h² / (8 a&sup4;) = Gc, so a = (3 E t³ h² / 8Gc)1/4: the crack grows like √h and always runs ahead of the wedge in a stable way. The wedge force is F = 2P tan(θ + atan μ); each blow spends 0.3 × Eblow = ∫F ds.

The thinnest sheet. The root bending stress while the crack runs is σ = √(6 E Gc / t), independent of the wedge opening. If it exceeds the strength σt the sheet snaps instead of peeling, so tmin = 6 E Gc / σt². Flaws (tough patches along the plane) briefly hold the crack back and raise the stress, so thin sheets snap there first.

Illustrative values. E = 60 GPa, Gc = 20 J/m², σt = 55 MPa, mallet efficiency 0.3 are plausible round numbers for roofing slate, not measurements of one quarry; real Gc varies strongly with the direction and the mica content. The sliders let you test other values.

Honest simplifications. Small-deflection beam theory with no root rotation (it slightly overestimates the stiffness of short cracks); the lower block is rigid and held down; the wedge loads the sheet at the mouth (a real chisel contacts it along the flank); flaws are a smooth random toughness profile; the vertical scale is exaggerated by the slider (a 6 mm sheet is very thin). The bench, wedge, mallet and slate pile are a Blender model that carries no data. This is physics education, not a guide to quarrying.

Independent checks (run on load; the same core drives the 2D page):

running…

Ready

Blows / energy used-
Wedge depth s-
Opening at mouth h-
Crack length a-
Wedge force F-
Root stress / strength-
Equilibrium stress-
Thinnest peelable sheet-
Press the mallet button (or Space) to drive the wedge. Orbit with a drag.
Made with 🟠 Blender · Three.js