Mine Flooding: Seepage, Pump Curve and How the Water Level Settles in a Shaft

Water seeps from the rock into a 200 m shaft with four levels of workings while a pump lifts it out: change permeability, pump size and water table and watch the level climb or settle.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

A vertical shaft 200 m deep with four levels of connected workings at 40, 80, 120 and 160 m is surrounded by a water-bearing rock mass whose water table stands 20 m below the surface (adjustable). Water seeps radially into the shaft; the pump at the bottom lifts it to a surface pond. The water level in the mine follows from the balance of seepage in and pumping out.

Equations

  • Seepage to a shaft in an unconfined aquifer (Dupuit-Thiem): Qin = π K (H2 − h2) / ln(R / rw), with H the aquifer head above the shaft bottom, h the water level in the shaft, K the hydraulic conductivity, R the radius of influence and rw = 2.8 m the equivalent shaft radius (25 m2).
  • Pump: a quadratic head-flow curve Hp = H0 (1 − (Q/Qm)2) against the static lift D − h plus a pipe loss that is 20 m at full flow. Electrical power P = ρ g Q H / η.
  • Storage: A(h) dh/dt = Qin(h) − Qp(h), where A(h) is the shaft area (25 m2) plus the connected workings area of each level the water is currently inside (4 m high). The ODE is integrated with fourth-order Runge-Kutta.
  • Equilibrium level: the root of Qin(h) = Qp(h), found by bisection. With the pump off the level rises towards the aquifer head.

Simplifications

  • The rock is a homogeneous, isotropic aquifer with a quasi-steady flow field and a fixed radius of influence; real mines have fractures, faults, karst conduits, layered rock and transient drawdown (storage coefficient is ignored), so the real inflow history can differ a lot. The default numbers are illustrative, not data from a specific mine.
  • All the workings of a level fill like one tank with a flat water surface; real workings are connected through narrow drifts, partly sealed and sloping, which delays and staggers the filling.
  • Water quality (acid mine drainage, dissolved metals) and the rock-mass stress changes of flooding are not modelled. No pump efficiency curve, cavitation or power outage is modelled beyond the on/off capacity slider.
  • The model is educational: it shows why a dewatering pump has to run for ever, which pump size is enough and how the level settles where seepage equals pumping. Do not use it to size a real pumping system.
Loading model...
Loading Blender model...
Water level against time
Seepage and pump flow against level
Days until level 1 floods against pump capacity
Made with 🟠 Blender · Three.js