LR
Rotating machinery · field study 08
The Applied Mechanics Collection
ENGINEERING NOTE / 418637
Gas handling · compression cycle

Liquid ring vacuum pump

Follow a gas pocket as the eccentric rotor carries it through expansion, suction, compression and discharge. Change the geometry and operating point to see where the vacuum comes from.

MODEL 01
ISOTHERMAL–POLYTROPIC
IDEALISED CYCLE

Chamber cross-section

01 / RE-EXPANSION
Seal liquidGas pocketRotor & bladesPorts

Pressure through one cell cycle

ABSOLUTE · kPa
Expansion and suction occupy the first half-turn; compression and discharge occupy the second.

Pressure–volume trace

p–V · PER CELL
The enclosed path is a simplified chamber cycle, not a measured pump map.

Capacity vs suction pressure

PARAMETER SWEEP
Illustrative theoretical capacity at the current speed and discharge pressure.
Independent p–V integral PASS · 0.000%
The science behind the cycle

Geometry. Each inter-blade pocket is represented by a sinusoidal volume, from clearance volume Vmin to maximum volume Vmax. The liquid ring is assumed to seal the blade tips. Eight pockets pass through the same cycle per rotor revolution.

Re-expansion and suction. Residual gas at discharge pressure expands polytropically until it reaches suction pressure: Vopen = Vmin (pd/ps)^(1/n). Fresh gas admitted per pocket is max(0, Vmax − Vopen). The model therefore captures clearance loss and the possibility of zero net intake at an extreme pressure ratio.

Compression. Fresh gas is compressed using pVⁿ = constant. Ideal compression work per pocket is ps · Vfresh · [r^((n−1)/n) − 1] / (n−1), with the logarithmic limit at n = 1. Ideal shaft demand is divided by a user-set mechanical efficiency. A separate empirical seal-liquid shear term is added; its coefficient is illustrative, not a universal pump constant.

Assumptions and limits. Air is ideal; pressure is absolute; cell volume is sinusoidal; port timing is ideal; heat transfer is condensed into the polytropic exponent; liquid dynamics, cavitation, slip, leakage, bearing losses and real pump maps are omitted. The temperature estimate follows the polytropic relation and is not a casing-temperature prediction. Numbers are illustrative engineering estimates, not a manufacturer performance curve.

Illustrative design, not affiliated with any real institution or manufacturer.

Made with 🤖 ChatGPT