Bolting the drum into the trough…
💧 Drum filter controls
2D version with Ruth plot and speed map →
The science

What happens. A drum covered with filter cloth turns slowly through a trough of slurry. Vacuum inside the drum sucks liquid through the cloth; solids stay behind as a cake. After leaving the slurry the cake is sucked dry, then a doctor knife lifts it off. Each patch of cloth filters only while it is submerged: tf = ψ · 60/n.

Ruth equation (constant pressure, v = filtrate per unit area): dv/dt = ΔP / [μ (α c v + Rm)], so t = (μαc/2ΔP) v² + (μRm/ΔP) v. Cake mass per area w = c v, thickness x = c v / (ρs(1−ε)), plant throughput Q = πDL · v · n/60. The average specific resistance follows α = α0 (ΔP/50 kPa)s, a standard power-law for compressible cakes.

What to try. Turn n up: the cake gets thinner and throughput rises only as √n. Past a thin limit the knife cannot lift the cake. Turn n down: the cake thickens, cracks and the vacuum leaks. Raise ΔP with s = 0.7: almost no extra flow.

Honest simplifications. Parameters are illustrative, not from a specific plant. Constant porosity (0.5), a single average α, no cake washing or moisture model, no cloth blinding, and no vacuum drop along the pipework. The knife minimum (2 mm) and the cracking limit (25 mm) are round numbers, not measured data. Cake height is exaggerated by the slider; the drum is drawn at real 2.8 m diameter. A cake that is too thin is drawn carried past the knife; in a real plant it would blind and foul the cloth.

Independent checks (run on load; the 2D page uses the same core):

running…

Operating point

Revolution time
Formation time tf
Cake thickness
Cake resistance / medium
Filtrate rate
Dry solids
Flux at end of cake
Drag to orbit. The 2.8 m drum is shown at real size; the cake height is exaggerated.
Made with 🟠 Blender · Three.js