Rendering the filter…
3D Blender plant →
Along the belt
cake thickness (of final), solute left, liquid saturation. Shaded: formation, wash, drying.
Wash curves: solute left against wash ratio W
Yellow: your Pe. Grey: Pe = 5, 30, 300. Dashed: piston flow 1 − W. Ring: applied W.
Belt-speed trade-off
dry solids (relative), moisture (of 25 %), solute left. Tap to set the belt speed.

🧱 Belt filter controls

Operating point

Time on belt f / w / d
Cake thickness
Wash applied W / cap
Solute left in cake
Cake moisture
Dry solids
The science

Three zones. Formation: Ruth cake growth dv/dt = ΔP / [μ(α c v + Rm)] with the slurry pool limited to depth h0. Washing: displacement of the pore liquor, limited by the water supplied or by Wcap = (ΔP/μR) tw / (ε x). Solute leaves as C/C0 = ½ erfc[(W−1)/(2√(W/Pe))], so the cake keeps 1 − ∫C/C0 dW. Drying: Darcy drainage with krw = S*3, S* = (1 + 2Kt)−1/2, residual saturation 0.25.

The trade-off. A faster belt gives a thinner cake and more dry solids per hour, but each zone lasts less time: less wash volume fits through, and the cake leaves wetter. The right-hand chart shows where each quality drifts away.

Honest simplifications. Illustrative parameters, not a specific plant. Porosity 0.45, one average specific resistance (s = 0.3), uniform vacuum per zone, a dispersion model that assumes an even cake, no cloth blinding. The belt frame is a Blender render; the cake, pool and zones are drawn live. Cake height is exaggerated by the slider.

Independent checks (run on load; the 3D page uses the same core):

running…
Made with 🟠 Blender