3D Campfire: Combustion, Flame Height and Radiant Heat

Build a campfire from logs of any size and dampness: watch the heat release, the Heskestad flame, the rising plume and the heat felt at a probe.

Switch to 2D

Presets

Playback

Fuel, air and site

Actions

Camera

Layers

Quality

Model check

The science

Fuel and heat release. A log of radius r and length L loses wood at its burning surface (sides and both ends) at a regression rate of order a millimetre per minute; here ṙ = β0·vent/(1 + 3u), slowed by moisture u (dry basis) and by crowding of the pile. The mass flow is ṁ = ρwetπ(2 r L ṙ + r2 ṙL), and the heat release rate is Q = ṁ · LHVwet · η. Wet wood gives less energy per kilogram because the water must be evaporated: LHVwet = (LHVdry - u hfg)/(1 + u) with LHVdry about 16.5 MJ/kg and hfg = 2.26 MJ/kg of water.

Flame height. Heskestad's correlation for turbulent diffusion flames: Lf = 0.235 Q2/5 - 1.02 D (Q in kW, D the diameter of the burning bed in metres). Doubling the heat release raises the flame by about 32 %, while a wider bed of the same Q lowers it. Above the flame the plume is described by the point-source plume laws ΔT0 = 25 Qc2/3/(z - z0)5/3 K and u0 = Qc1/3/(z - z0)1/3 m/s with Qc = 0.7 Q and virtual origin z0 = 0.083 Q2/5 - 1.02 D.

Radiation. A fraction χr = 0.3 of Q leaves as thermal radiation. Treating the flame as a point source gives q = χr Q/(4πR2) on a surface facing it: the probe reading falls with the square of the distance. For comparison, full midday sun delivers about 1 kW/m2.

Honest simplifications. The regression rate, the crowding factor 1/(1 + 0.08(n - 1)) and the wind tilt (tanθ = 0.6 uwind/u*, with u* = (gQ/(ρ cp T D))1/3) are simple engineering approximations chosen to give realistic magnitudes, not measured laws. The fire is quasi-steady per log, the logs burn evenly without collapsing, and combustion efficiency is a constant 0.85. The Heskestad constants are for steady pool-like fires and only roughly describe a flickering woodpile. CO2 is counted as 1.83 kg per kg of dry wood burnt (about 50 % carbon), which is climate-neutral only if the wood is replaced. The flame particles are an artistic rendering driven by the computed flame height, tilt and heat release. Keep real fires away from tents and dry grass and never leave them unattended.

Loading model...
Loading Blender model...
Heat release of the fire over time
Flame height against heat release
Thermal radiation against distance
Plume temperature rise above the flame
Made with 🟠 Blender · Three.js