3D Pottery Wheel: Throwing a Vessel at Constant Clay Volume

Centre, open and pull a pot in a Blender-built studio: volume conservation, wheel speed, hoop stress and the yield limit of wet clay.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

A lump of wet clay is centred on the wheel, opened and pulled up into a vessel. The clay cannot be created or destroyed, so the finished shape is built to keep the volume exactly equal to the mass divided by the density: thinner walls make a taller pot, a bigger belly makes a shorter one. The outside profile is a smooth curve with belly, neck and rim flare; the inside follows it at the wall thickness. On top of the geometry the page models the two ways wet clay fails: the wheel flings the wall outwards (the hoop stress of a spinning ring), and the wall slumps under its own weight. The studio, wheel, tools and shelf pots are Blender-built models; the vessel itself is generated from the equations every frame.

Equations

  • Outer profile ro(z) = k Rb [1 + belly sin(π z/H) − neck (z/H)² + flare smoothstep(0.88, 1, z/H)], wall ri = ro − t, floor thickness tb.
  • Volume conservation: V = π ∫0H ro² dz − π ∫tbH ri² dz = m/ρ; H is found by bisection (ρ = 1700 kg/m³ for wet stoneware).
  • Wheel: ω = 2πn/60, rim speed v = ω r, centripetal acceleration ω² r. A thin spinning ring of clay carries the hoop stress σc = ρ ω² r², so the critical speed is nc = (60/2π) √(σy/ρ) / r.
  • Wet clay is a Bingham solid with yield stress σy and plastic viscosity η: above yield d ln k/dt = (σ − σy)/η. Because σc grows with r², the flow accelerates (a runaway) once the stress is above yield. The column of wall carries σv = ρ g H; the plastic-collapse height is σy/(ρ g).
  • Droplets of slip leave the rim along the tangent with v = ω r and fly as projectiles.

Checks run in the page

  • Volume of the finished vessel by 6000-slice integration against m/ρ.
  • The same volume from Pappus' theorem (polygon area times 2π times the centroid radius).
  • Stepped Bingham spin-out flow against its closed-form solution.
  • A flung droplet against the projectile formula.

Honest simplifications

The vessel shape is a parametric family, not the outcome of simulating the potter's fingers; the throwing progress simply blends from the lump to the vessel at constant volume. Wall buckling, uneven thickness, off-centre wobble and drying shrinkage are not modelled. The yield stress and viscosity are typical round values for soft stoneware (a few to a few tens of kPa), not measurements of a particular clay.

What to try

  • Choose Too fast: it spins out and watch the stretch factor k grow while the vessel flares and shrinks in height.
  • Choose Soft clay slumps, then stiffen the clay with the yield stress slider.
  • Make the walls thinner and see the vessel grow taller from the same clay (right graph).
  • Switch on the half cut-away to see the wall thickness.
Loading model...
Loading Blender model...
Vessel cross-section
Hoop stress vs wheel speed
Height vs wall thickness (same clay)
Made with 🟠 Blender · Three.js