Overshot Waterwheel

2D twin of the 3D waterwheel: water falls into buckets at the top, the filled buckets turn the wheel, and spill reduces the useful energy.

Presets

Playback

Water, wheel and load

A heavier load slows the wheel, which gives the buckets more time to fill, until the buckets are full and the wheel stalls. Spilling early wastes part of the fall height.

Model checks

The science

What is modelled

Water at flow Q falls into the buckets at the top of a wheel of diameter D. Each bucket holds up to Vb litres and keeps its water until the spill angle, after which the retained fraction falls linearly to zero at the bottom. The wheel speed follows from the torque balance with a load and viscous friction.

Equations

  • Fill per bucket v = min(Vb, Q / (N w / 2π)).
  • Torque T = ρ g R v (N / 2π) I with I = ∫ sinθ r(θ) dθ over 0 to π.
  • Speed: J dw/dt = T(w) - Tload - c w.
  • Water power P = ρ g Q D; efficiency T w / P, which equals I/2 while no water overflows.

Checks run in the page

  • The bucket-torque integral against its closed form.
  • The simulated steady speed against root finding and the quadratic solution.
  • The efficiency I/2.
  • Water caught against water supplied.

Honest simplifications

The buckets are treated as a continuous ring, the retained water falls linearly with angle, the head is taken as the wheel diameter, and the centrifugal effect, the weight of the wheel and the water-entry impact are ignored. Real wheels reach about 60 to 85 percent.

What to try
  • Press Free running: the speed is limited only by friction and the efficiency is highest.
  • Press Small buckets (spill): the stream is larger than the buckets can carry and water overflows.
  • Raise the load torque until the wheel stalls.
Wheel speed against time
Bucket torque and load line
Useful power against load torque
Efficiency against spill angle