Planetary gearing turns rotational speed into usable torque.
This interactive engineering exhibit visualizes a fixed-ring, sun-driven planetary transmission with a rotating three-planet carrier. Unlike a decorative animation, its shafts follow a consistent gear ratio while a torque-limited motor model responds to changing output resistance. The detailed assembly includes helical involute-like tooth profiles, bearings, shaft couplings, fastening hardware, a partially transparent inspection cover, and an electric drive unit.
Holding the ring stationary makes the carrier rotate at 18/66 of the sun speed. Planet spin follows the relative motion between carrier and sun.
A fixed-step angular acceleration model combines commanded torque, reflected load, and viscous drag. High load can stall the motor.
The dashboard reports shaft power from computed motor torque and angular speed. An assumed 93% transmission efficiency represents mechanical losses.
Explore the engineering behind the drive
1. What is a planetary gearbox?
It is a compact transmission built around a central sun gear, multiple planet gears, an outer ring gear, and a carrier supporting the planet shafts. Power and motion are divided among several tooth contacts, making the layout useful where substantial torque must fit into a short, coaxial package.
2. Why does this simulation use a 3.667:1 gear ratio?
The ring has 48 teeth and the sun has 18. For a stationary ring, a sun input, and a carrier output, the reduction is 1 + 48/18 = 3.6667. The 15-tooth planet gears fit geometrically because 48 = 18 + 2 × 15 for equal gear module.
3. What is the purpose of the fixed ring gear?
The stationary internal ring provides the second tooth contact for each planet. Its constraint forces the planets to spin while orbiting the sun, translating relatively fast sun motion into slower carrier rotation. If the ring were free to rotate, a different constraint or additional input would be required to determine the output.
4. Why are helical teeth used?
Helical teeth enter and leave contact progressively along their face width, potentially producing smoother transmission and lower noise than comparable straight-cut gears. Helix angle also introduces axial thrust, so real helical gearboxes need suitable thrust bearings and tooth geometry.
5. What happens when output resistance increases?
The output load is reflected to the motor as an opposing input torque divided by the product of gear ratio and assumed efficiency. The controller raises motor torque to maintain target speed until the torque limit is reached. Beyond that limit, shaft speed falls and may stall.
6. Is the motion frame-rate independent?
Yes. The motor dynamics are integrated at a fixed 1/120-second simulation step, independently of display frame time. Animation frames only draw the latest state. The speed multiplier scales simulation time, while very long background-tab gaps are clamped to avoid unrealistic catch-up jumps.
7. What does the planet spin measurement represent?
It reports the angular velocity of each planet around its own shaft in the fixed laboratory reference frame. Each planet also orbits the sun with the carrier. The two types of motion are related by the external sun-to-planet tooth contact.
8. Does the temperature readout model real lubrication?
Not in full detail. It is a simplified lumped thermal model with heat input from estimated drivetrain loss and torque-dependent motor heating, opposed by linear cooling to ambient. It illustrates thermal trends but is not a replacement for bearing, gear-mesh, and oil-flow design calculations.
9. Can this model predict the strength of an actual gearbox?
No. The geometry is a high-detail visualization with approximate helical and involute-like profiles. It does not solve tooth contact stress, lubrication film, fatigue, backlash, thermal expansion, shaft bending, or manufacturing tolerances. Mechanical design requires validated engineering analysis and testing.
10. How should I explore the simulation?
Rotate with the mouse or a finger, zoom with the wheel or a pinch, and pan with the secondary mouse button. Change target RPM, motor torque limit, and output resistance to test motor behavior. Use the axial profile, exploded assembly slider, clear-cover toggle, and click-to-inspect selection to study the component layout.