Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
A fleet of haul trucks climbs a decline (an inclined mine road) with ore from a loader at the bottom to a hopper at the top, and returns empty. The ramp is drawn straight; a real decline is usually a spiral, which changes the curve resistance and the speed on bends but not the climb physics.
Truck on a grade
With grade angle theta (tan theta = rise/run), mass m, rolling resistance Crr, air density rho and drag area CdA:
m (1+k) dv/dt = F_drive - m g sin(theta) - Crr m g cos(theta) - 1/2 rho CdA v^2, with F_drive = min(P / v, mu m g cos(theta)).
The steady climbing speed solves P = v F_resist(v). For the default 72 t loaded truck on 12.5 % this is about 2.9 m/s (10.6 km/h) with 340 kW at the wheels: nearly all the power lifts the load, and the speed falls as 1/grade. Downhill an empty truck is pulled by m g (sin theta - Crr cos theta); the retarder must turn that force times the speed into heat and can absorb 600 kW, so the descent speed is the smaller of the speed limit and P_ret / F_net. Starts are limited to 1 m/s2 (operator and transmission) and to a 0.45 traction coefficient.
One-lane traffic
The road is one lane wide. The ramp is split into blocks by passing bays; a block may hold trucks in only one direction. A truck asks for the next block when it is within its braking distance plus 30 m and stops in the bay niche if it is refused; loaded uphill trucks have priority, but a convoy is cut after an opposing truck has waited 90 s. Trucks in the same direction keep a headway of 1.5 s and a stopped gap of 2 m. The loader serves one truck at a time (4 bucket passes of 10 t, 36 s each), the hopper one truck at a time (45 s including the tipping), and both ends have a turning yard where trucks drive at 3 m/s.
Fuel, heat and air
Engine fuel is the wheel work divided by the driveline efficiency (0.85) and the thermal efficiency of the diesel (0.38, lower heating value 42.8 MJ/kg) plus an idle burn of 5 kg/h per engine; CO2 uses 3.16 kg per kg of diesel. The fresh-air figure uses the common design rule of about 0.06 m3/s per kW of rated diesel power; actual regulations differ by country and by engine emission class.
Simplifications
- Straight ramp, constant grade, no curves, no gradient changes, no wet or icy spots; the road resistance is one number.
- Four wheels, no articulation or tyre slip model; traction is a simple coefficient.
- Bay capacity is not limited (several trucks may wait side by side); no breakdowns, shift changes, blasting or ventilation stops.
- The speed limit, payload, loading and dumping times, retarder capacity and the 40 t truck class are typical round numbers, not the data of any vehicle or mine.
- The traffic rules are a simple reservation scheme, not a real dispatch system; real mines also use signals and radio.
Checks in the page
The five checks compare the integrated climb with the closed-form speed, close the energy ledger, compare the simulated cycle of a lone truck with a formula, test the traffic invariant (no head-on overlap) together with Little's law at the loader yard, and compare the Blender truck with the dimensions the model uses.