A 10 m section of an inclined belt conveyor: drive tension, capstan slip and head-pulley discharge. Drag to orbit, scroll to zoom, click an item to inspect it, Space pauses.
-Material on the belt (kg/m)
-Effective tension T_e (kN)
-Slack tension needed (kN)
-Tight-side tension (kN)
-Motor power (kW)
-Energy per tonne (kWh/t)
-Froude number v^2/(gR)
-Discharge
-Drive pulley
-Items on the belt (mean mass in kg)
The science
The motor must supply the effective tension T_e = f g L cos(a) (q + q_b + q_r) + g q L sin(a): rolling resistance of the idlers and belt flexing (factor f), plus lifting the material up the incline. Here q = Q / (3.6 v) is the material mass per metre (Q in tonnes per hour), q_b the belt and q_r the idler rotating mass per metre. The motor power is P = T_e v / eta.
The drive pulley moves the belt through friction on its wrapped arc, described by the capstan (Euler-Eytelwein) equation T1 / T2 <= e^(mu theta) with T1 = T2 + T_e. A smaller wrap angle or lagging friction forces a higher slack-side tension from the take-up; if the take-up is set below T_e / (e^(mu theta) - 1) the belt slips - in this model the belt then crawls at about 55 percent of the pulley speed and the status light turns red.
At the head pulley an item follows the belt only if gravity can supply the centripetal force; the Froude number v^2 / (g R) above about 1 means it is thrown off along a projectile path, x = v t cos(a), y = v t sin(a) - g t^2 / 2, and you can watch it land in the catch bin. Below 1 it sticks to the belt, loses its speed round the pulley and drops.
Honest simplifications: the model shows 10 m of belt, but the tensions and power use the full conveyor length L you set; the 95 percent drive efficiency and constant resistance factor are typical values; secondary resistances (skirts, ploughs, belt-bending detail), sag between idlers, belt stretch dynamics, start-up transients and the exact release angle at the pulley are ignored. Items are crates or rock lumps of equal mass drawn to match the throughput; for very high throughputs they are drawn heavier so that the picture stays readable.
Independent educational model; not a design tool for real conveyors.