INTERCONNECTED ENGINEERING SIMULATION FAMILY

Explore the operating physics of a centrifugal pump system

Eight complementary laboratories share one hydraulic model. Change the pump, pipeline, fluid or suction conditions and carry the same scenario into every experiment. All calculations run locally in your browser.

8 modules · offline-ready

Live system snapshot

Calculated from the current shared parameter set
STEADY STATE

What connects the laboratories?

One consistent pump–network calculation, reused throughout
1
Pump characteristic

Affinity-scaled head–flow curve, pump arrangement and efficiency envelope.

2
Pipeline resistance

Darcy–Weisbach distributed losses plus local losses and static elevation.

3
Operating point and energy

Numerical curve intersection, hydraulic power, shaft input and electrical demand.

4
Suction safety

Available versus required NPSH using temperature-dependent water properties.

Simulation modules

Choose a laboratory. Shared parameters are preserved during navigation.
◉

01 · Hydraulic cutaway

Explore the reservoir, suction line, impeller, discharge pipe, pressure gauges and moving flow.

Open cross-section →
⌁

02 · Curve laboratory

Find the pump–system intersection and inspect efficiency, power and head curves.

Open curve lab →
⏱

03 · Start-up experiment

Run a time-domain start-up experiment with a speed ramp and hydraulic inertance.

Open experiment →
⇄

04 · System comparison

Compare baseline, larger pipe, variable-speed and parallel-pump configurations.

Open comparison →
∑

05 · Model explorer

Inspect the equations, Reynolds number, friction factor, losses and affinity scaling.

Open model explorer →
◇

06 · Design challenge

Meet a flow target while satisfying power and NPSH safety constraints.

Open challenge →
▥

07 · Data analysis

Sweep pump speed, compare operating points, export CSV and generate a report.

Open data analysis →
≈

08 · Cavitation & NPSH

Study vapour pressure, suction losses and the margin against cavitation.

Open cavitation lab →
Engineering scope: this is an educational, steady-state pump-curve model with a simplified one-dimensional start-up transient. It is not a certified pump selection tool, CFD solver or substitute for manufacturer performance curves and site measurements.
Made with 🤖 ChatGPT · Three.js