A Blender-modelled beach walker: 12-bar legs, a vertical-axis sail and an exact kinematic no-slip gait.
GraphsToe path in the body frame (orange: grounded arc, dot: now)
Foot speed relative to the ground over one crank turn: zero while grounded
Wind and walking speed, last 60 s
The science
Jansen linkage. Each leg is a planar chain of 12 rigid bars. With a crank of radius r turning at angle θ, every joint is found by intersecting two circles: |P - Q1| = L1 and |P - Q2| = L2. The two roots are separated by tracking the previous frame, so the mechanism never flips branch. The bar lengths (in units) are a=38, b=41.5, c=39.3, d=40.1, e=55.8, f=39.4, g=36.7, h=65.7, i=49.0, j=50.0, k=61.9, frame pivot offset l=7.8 (up), crank m=15 (Jansen's published numbers); one unit is 3 cm at gait scale 1. The joint topology is reconstructed from the lengths and chosen for a flat grounded phase; it is a Jansen-type linkage, not a verified copy of his drawing.
Walking without slipping. While the foot is on the ground, it must not move relative to the sand, so the body speed equals the backward speed of the foot in the body frame: u = ω · |dxtoe/dθ|. The page measures the grounded arc of the toe path (toe within 9 cm of its lowest point), its length and its crank angle, and uses the mean of |dx/dθ| over that arc as the kinematic constant KR (metres of ground per radian). Then ω = u / KR. The foot is not perfectly flat, so a small residual slip remains: it is shown in the second graph and in check 2.
Wind power. The rotor captures P = ½ ρ A Cp v3 with air density 1.2 kg/m3, swept area A and power coefficient Cp (the Betz limit is 16/27 = 0.593; real rotors reach 0.2 to 0.4). A fixed transmission efficiency of 0.65 covers friction in the many joints.
Resistance. Walking in sand costs a rolling-type force F0 = μ m g plus aerodynamic drag ½ ρ CdA u2 (CdA fixed at 1.5 m2). The steady speed solves F0 u + ½ ρ CdA u3 = η P (bisection). Speed approaches it with the first-order lag τ = 0.5 + m/80 s, a rough stand-in for inertia.
Cost of transport CoT = P / (m g u) uses the captured shaft power; compare about 0.3 for a walking person.
Honest simplifications. Legs of one pair move in unison and pairs are offset by the chosen phase; there is no sand deformation, no body pitch, no leg inertia, and the rotor torque curve is replaced by the power balance. The real Strandbeest also uses pressure tubes and a wind-sensing anchor; those are not modelled. Not a structural analysis.
What to try: raise the wind from 3 to 9 m/s and watch the speed grow with the cube root (power balance dominated by sand friction at low speed); switch to the soft-sand preset to see the cost of transport rise; reduce the pairs to 2 and notice that fewer legs are grounded at once; change the phase offset to 60 degrees and see how many feet touch down together.